User manual PIONEER SX-690 service additional

[. . . ] To prevent a fire or shock hazard, do not place any container filed with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain D3-4-2-1-3_A_En or moisture. WARNING Before plugging in for the first time, read the following section carefully. The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. g. , 230V D3-4-2-1-4_A_En or 120V) written on the rear panel. Operating Environment Operating environment temperature and humidity: +5 ºC ­ +35 ºC (+41 ºF ­ +95 ºF); less than 85 %RH (cooling vents not blocked) Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or D3-4-2-1-7c_A_En strong artificial light) This product is for general household purposes. Any failure due to use for other than household purposes (such as longterm use for business purposes in a restaurant or use in a car or ship) and which requires repair will be charged for even during the warranty period. [. . . ] You can resume playback from the same point by pressing . (Press again to cancel the resume function. ) DVD MENU TOP MENU ENTER RETURN Press to return to the previous level of a DVD-Video disc menu. 53 En 04 Getting started · During playback, press to start scanning. Press repeatedly to increase the scanning speed. · Press and hold while paused to start slow-motion playback. Press repeatedly to change the playback speed (forward direction only). · While paused, press to advance a single frame (forward direction only). PREV NEXT 1 Press SHIFT and DISPLAY repeatedly to display/ change the on-screen information. · The on-screen display automatically disappears after 20 minutes. 2 To hide the information display, press SHIFT and DISPLAY repeatedly until it disappears. The example displays below are a guide only; actual displays vary according to the disc loaded, etc. Press to skip to previous/next track. (You can also use the front panel +/­ buttons to do this during playback. ) When a PBC menu is displayed, press to display the previous/next page. Each press skips forward progressively up to a maximum of ten minutes. Stop display 1 12 Stop DVD-RW VR Original 3 4 Pr 01 Stereo 5 10:10 SAT 12/12/2005 CM SKIP During playback, enter a track number then press ENTER to skip directly to that track. 2 Copy protected material (!)/ PureCinema indicator (#) Shows `!' if the playback material is copy-once protected. Shows `#' if the video output is 24 fps, progressive scan. 3 4 5 Current title name Total running time of title Total number of chapters in title 55 En 05 Playback Chapter 5 Playback Introduction Most of the features described in this chapter make use of on-screen displays. Navigate these using the / / / (cursor buttons) and ENTER. To go back one level from any screen, use the RETURN button. Remember also that the button guide at the bottom of every screen shows which buttons do what. Many of the functions covered in this chapter apply to DVD discs, Video CDs, CDs, and MP3 discs, although the exact operation of some varies slightly with the kind of disc loaded. The following icons are provided to help you quickly identify which instructions you need for which kind of disc. DVD DVD-Video The DVD side of a DualDisc plays in this product. For more detailed information on the DualDisc specification, please refer to the disc manufacturer or disc retailer. Using the Disc Navigator to browse the contents of a disc Use the Disc Navigator to browse the contents of a recordable disc and start playback. VIDEO INPUT Any kind of DVD, DVD-R or DVD-RW Commercially produced DVD or finalized Video mode DVD-R/RW Video mode DVD-R/RW (unfinalized) CLEAR DISC NAVIGATOR TUNE + DVD MENU TOP MENU RDS DISP ST ­ HOME MENU SYSTEM SETUP ENTER ST + RETURN Video mode VR mode CD Video CD MP3 TEST TONE TUNE ­ DISPLAY VR mode DVD-RW Audio CD Video CD MP3 files Using the Disc Navigator with recordable discs VR mode Video mode · Some DVD-Video discs don't allow certain playback controls to operate at certain points in the disc. · When playing Video CDs, some functions are not available in PBC mode. · When playing an NTSC disc, the video output will be PAL. [. . . ] AV connector 2 (input 1) RCA jack (input 2) Video output. AV connector 1 (AV1) RCA jack (Output) S-Video input . AV1 / Output Y (luminance) - Output level . . AV connector 1 (AV1), 4 pin mini DIN Component video output Output level. [. . . ]