User manual PIONEER SX-980

[. . . ] In some countries or regions, the shape of the power plug may sometimes differ from that shown in the explanatory drawings. However, the method of connecting and operating the unit is the same. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This Class B digital apparatus complies with Canadian ICES-003. [. . . ] CLASS Switches between the three banks (classes) of station presets (page 23). TONE Press to access the bass and treble controls, which you can then adjust with the remote's BASS and TREBLE buttons (page 21). 3 TUNER indicators Lights when a stereo FM broadcast is being received in auto stereo mode. Lights when the mono mode is set using the MPX button (page 23). 2 PL II Lights when the receiver is using Dolby Pro Logic II decoding. Character display TONE Lights when the receiver is in tone mode. SOUND Lights when the receiver is in sound mode. SLEEP Lights when the receiver is in sleep mode. Lights when a broadcast is being received. 1 STANDBY/ON This switches between standby and on for this receiver (page 16). 2 MUTE Press to mute the sound (press again, or adjust the volume, to restore the sound). Remember that when the receiver is in standby it still uses a small amount of power (0. Unplug from the wall outlet to completely disconnect the power. The receiver will retain its settings for about four weeks when unplugged. 1 If the receiver isn't already on, press STANDBY/ON (remote or front panel) to switch on. If any of the speaker distance settings have been changed (see Setting speaker distances below) then the display blinks ROOM SET. 3 Use the ROOM SETUP button to select a room size setting, then press ENTER. select from: · Room S ­ Smaller than average room (approx. Room L ­ Larger than average room (approx. Seat Fwd ­ If you are nearer to the front speakers than the surround speakers · Seat Mid ­ If you are equal distance from the front and surround speakers · Seat Back ­ If you are nearer to the surround speakers than the front speakers After selecting the seating position, the display shows the new settings for a couple of seconds. 4 Press SYSTEM SETUP again to select the suround speaker distance setting, then set using the / (cursor left/right) buttons. The display shows: S c h : followed by the current distance setting. [. . . ] Turn off the equipment causing the noise or move it away from the receiver. Move antennas farther away from equipment causing the noise. No sound from surround or center speakers. If the subwoofer has a volume knob, make sure it's turned up. [. . . ]