User manual PIONEER TS-A1323I

[. . . ] If you experience problems Should this product fail to operate properly, please contact your dealer or nearest authorized Pioneer Service Station. Before connecting/ installing the amplifier WARNING If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. This unit is for vehicles with a 12 V battery and negative grounding. [. . . ] 3 GAIN (gain) control Adjusting gain controls CHANNEL A (channel A) and CHANNEL B (channel B) helps align the car stereo output to the Pioneer amplifier. default setting is the NORMAL position. If output remains low, even when the car stereo volume is turned up, turn controls to lower level. If distortion occurs when the car stereo volume is turned up, turn these controls to higher level. If using only one input plug, set the gain controls for speaker outputs A and B to the same position. For use with an RCA equipped car stereo (standard output of 500 mV), set to the NORMAL position. For use with an RCA Setting gain properly !Protective function included to prevent malfunction of the unit and/or speakers due to excessive output, improper use or improper connection. , this function cuts off the output for a few seconds as a normal function, but output is restored when the volume of the head unit is turned down. A cut in sound output may indicate improper setting of the gain control. To ensure continuous sound output with the head unit at a high volume, set amplifier gain control to a level appropriate for the preout maximum output level of the head unit, so that volume can remain unchanged and to control excess output. Before connecting the amplifier WARNING !Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap sections in contact with metal parts in adhesive tape. Never cut the insulation of the power supply to feed power to other equipment. current capacity of the wire is limited. 6 En Section Connecting the units In addition, refer to the speaker instruction manual for information on the correct connection procedure. For any further enquiries, contact your local authorized Pioneer dealer or customer service. Never shorten any wires, the protection circuit may malfunction. Never wire the speaker negative cable directlyto ground. Never band together multiple speaker’s negative cables. If the system remote control wire of the amplifier is connected to the power terminal via the ignition switch (12 V DC), the amplifier will remain on with the ignition whether the car stereo is on or off, which may exhaust battery if the engine is at rest or idling. [. . . ] Battery wire and ground wire size Wire length less than 4. 5 m Wire size 8 AWG 6 AWG 4 AWG Solderless terminal connections !Since the wire will become loose over time, it must be periodically inspected and tightened as necessary. Do not solder or bind the ends of the twisted wires. [. . . ]