User manual PIONEER TX-555Z

[. . . ] 3 Pay close attention to all warnings in this manual and follow the instructions carefully. 4 Do not allow other persons to use this system until they have read and understood the operating instructions. 5 Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. 6 Do not operate this display if doing so in any way will divert your attention from the safe operation of your vehicle. [. . . ] If high sound is crippled or distorted, try switching to LOW. Normally, leave the setting at HIGH to ensure quality sound. Only when the multi-channel processor (e. g. , DEQ-P7650) is connected to this unit, you can operate this function. 1 Touch NEXT on the initial menu. Resetting the audio functions You can reset all audio functions except volume. Only when the multi-channel processor (e. g. , DEQ-P7650) is connected to this unit, you can operate this function. ATT to switch the digital attenuator setting. ATT switches the digital attenuator settings in the following order: HIGH--LOW 4 Touch RESET again to reset audio functions. # To cancel resetting the audio functions, touch CANCEL. Switching the sound muting/ attenuation Sound from this system is muted or attenuated automatically when the signal from the equipment with mute function is received. 1 Touch NEXT on the initial menu. Setting the TV signal When this unit is connected to a TV tuner, you need to adjust the TV signal suitable to your country TV signal setting. This function is initially set to AUTO so that this unit automatically adjusts the TV signal setting. 1 Touch NEXT on the initial menu. 2 Touch TEL/GUIDE to select any of the muting, attenuation or off. Touch TEL/GUIDE until the desired setting appears in the display. 44 En Section Operating this unit 03 2 Touch TV SIG to select an appropriate TV signal. GND ­ When the polarity of the connected lead is negative while the gear shift is in REVERSE (R) position Setting the automatic open function To prevent the display from hitting the shift lever of an automatic vehicle when it is in P (park) position, or when you do not wish the display to open/close automatically, you can set the automatic open function in the manual mode. Furthermore, to adjust the LCD panel slide position, you can turn the set back on or off. 1 Touch FLP ST on the setup menu. This unit features a function that automatically switches to the rear view camera video (REAR VIEW CAMERA IN jack) when a rear view camera is installed on your vehicle. When the gear shift is in REVERSE (R) position, the video automatically switches to a rear view camera video. (For more details, consult your dealer. ) 46 En Section Operating this unit 03 2 Touch a to turn the set back on and the LCD panel slides to the back. # Touch b to turn the set back off and the LCD panel slides to the front. Notes !You can match the clock to a time signal by touching JUST. -- If the minute is 00 to 29, the minutes are rounded down. (e. g. , 10:18 becomes 10:00. ) -- If the minute is 30 to 59, the minutes are rounded up. Even when the sources are off, the clock display appears on the display. Operating this unit 3 Touch c or d to select the display to open/close automatically or manually. Touch c to select MANUAL, and you have to press OPEN/CLOSE to open/close the display. Touch d to select AUTO, and the display automatically opens/closes when power to this unit is turned on. Using the AUX source Setting the clock Use these instructions to set the clock. [. . . ] 16/20/24; linear Frequency response . . . . . . . . . . . . . . . 5 Hz to 44 000 Hz (with DVD, at sampling frequency 96 kHz) 82 En Appendix Additional Information Signal-to-noise ratio . . . . . . . . . . . . . . . 97 dB (1 kHz) (IEC-A network) (CD: 96 dB (1 kHz) (IEC-A network)) Dynamic range . . . . . . . . . . . . . . . . . . . . . . . . . 95 dB (1 kHz) (CD: 94 dB (1 kHz)) Distortion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]