User manual PIONEER TX-8100 service manual

[. . . ] Do not allow this unit to come into contact with liquids. Also, damage to this unit, smoke, and overheating could result from contact with liquids. Always keep the volume low enough to hear outside sounds. If the battery is disconnected or discharged, any preset memory will be erased. [. . . ] Important Be sure to park your vehicle in a safe place and apply the parking brake when performing this operation. After selecting, perform the following procedures to set the function. MISSED (missed call history) DIALED (dialed call history) RECENT (received call history) 1 2 3 4 Press M. When you find a phone number that you want to store in memory, press and hold one of the preset tuning buttons (1 to 6). The phone book in your cellular phone will be transferred automatically when the phone is connected to this unit. Depending on the cellular phone, the phone book may not be transferred automatically. In this case, operate your cellular phone to transfer the phone book. The visibility of this unit should be on. To select the first letter of the name you are looking for. To select a phone number you want to call. When you find a phone number that you want to store in memory, press and hold one of the preset tuning buttons (1 to 6). For more details, refer to AUX (auxiliary input) on this page. Use speakers over 50 W (output value) and between 4 W to 8 W (impedance value). Do not use 1 W to 3 W speakers for this unit. When installing this unit or power amp (sold separately), make sure to connect the ground wire first. Ensure that the ground wire is properly connected to metal parts of the car's body. The ground wire of the power amp and the one of this unit or any other device must be connected to the car separately with different screws. If the screw for the ground wire loosens or falls out, it could result in fire, generation of smoke or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. -- Place all cables away from moving parts, such as the gear shift and seat rails. -- Place all cables away from hot places, such as near the heater outlet. [. . . ] This unit supports only the following iPod models. supported iPod software versions are shown below. 3) Depending on the generation or version of the iPod, some functions may not be available. Pioneer accepts no responsibility for data lost on the iPod, even if that data is lost while this unit is used. [. . . ]