User manual PIONEER TX-9800

[. . . ] Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meets the FCC/IC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) exposure rules. This equipment has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio (SAR). [. . . ] # If only one device was found, this step cannot be performed. # Push MULTI-CONTROL left or right to switch the BD address and device name. # If device name cannot be obtained, BD address is displayed. # If multiple Bluetooth devices have been connected and you wish to disconnect them, press MULTI-CONTROL and then select the device. In this case, repeat operation from step 3. # Profile that is not compatible with the connected device cannot be selected. 3 Push MULTI-CONTROL left to switch to the version of the Bluetooth module of this unit. It is possible to set the automatic connection between your Bluetooth device and this unit. If this function is set to on, connection between your Bluetooth device and this unit will take place automatically as soon as the two devices are less than a few meters apart. If your Bluetooth device is ready for Bluetooth wireless connection, connection to this unit is automatically established. # To turn automatic connection off, press MULTI-CONTROL again. This entails establishing a Bluetooth wireless connection between this unit and your Bluetooth audio player, and pairing your Bluetooth audio player with this unit. % Connecting and pairing For detailed instructions on connecting your phone to this unit via Bluetooth wireless technology, see following section. If you do not operate functions within about 30 seconds, the display automatically returns to the ordinary display. Playing songs on a Bluetooth audio player % Selecting a track Push MULTI-CONTROL left or right. Since this unit is on standby to connect with your cellular phone via Bluetooth wireless technology, using this unit without running the engine can result in battery drainage. Advanced operations that require your attention such as dialing numbers on the monitor, using phone book, etc. When you need to use these advanced operations, stop your vehicle in a safe place. Depending on the cellular phone connected to this unit, the operations available with this unit may be limited. Lular phone remains muted even after the cellular phone is disconnected. Making a phone call dial a number The most basic way to make a call is to simply dial the number. For detailed instructions, refer to Making a call by entering phone number on page 36. [. . . ] For USB portable audio players, the sequence is different from that of USB memory and depends on the player. The user cannot assign folder numbers and specify the playback sequence with this unit. However, depending on the system environment, you cannot specify the file playback sequence. Up to 65 535 files on a USB portable audio player/USB memory can be played back. [. . . ]