User manual PIONEER VSX-35TX

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] MIDNIGHT indicator Lights when MIDNIGHT listening mode is in use. LOUDNESS indicator Lights when the LOUDNESS is on. LOUDNESS is used to boost the bass and treble when listening at low levels. 0 SPEAKER indicator Shows if the speaker system is on or not. SP 3A (and/or) B means speakers are switched on. - MONITOR indicator Lights when MONITOR is selected to hear a recording as it's being made (see page 34). = TUNER indicators MONO: Lights when the mono mode is set using the MPX MODE button. TUNED: Lights when a broadcast is being received. STEREO: Lights when a stereo FM broadcast is being received in auto stereo mode. ~ MASTER VOLUME LEVEL Shows the overall volume level. Volume level is maintained even when the power is off. ---dB indicates the minimum level, and 0dB indicates the maximum level. · Depending on the level settings you make for individual channels, the MAX level can range between ­10dB and 0dB. Also, this is the pause button for CDs, tapes, DVDs, etc. ACCESS button (see page 32) Use to directly access a radio station by pressing the number of the station you want. DTV INFO button Use to bring up information screens on a digital TV. DTV MENU button Use to bring up menus on a digital TV. DTV ON/OFF button Use to turn a digital TV on/off. GUIDE button Use to bring up the guides on a digital TV. 24 En Displays & Controls 6 2 /DTS button (see pages 27, 29) Use to put receiver in DOLBY DIGITAL, DOLBY SURROUND and DTS modes. DSP button (see pages 28, 30) Use to put receiver in one of the DSP modes. TEST TONE button (see page 21) Use to sound the TEST TONE when setting up the surround sound of the receiver (the 2 /DTS mode must be on). SIGNAL SELECT (see page 29) Use to select the proper signal (analog, digital) for the source your are inputting. On the VSX-D810S & VSX-D850S receivers there is an AUTO setting. In this setting the receiver will automatically switch between the analog and digital signals according to what is being input. [. . . ] One that lets the sound come through loud and clear without annoying blaring or distortion-and, most importantly, without affecting your sensitive hearing. Over time your hearing "comfort level" adapts to higher volumes of sound. So what sounds "normal" can actually be loud and harmful to your hearing. Guard against this by setting your equipment at a safe level BEFORE your hearing adapts. [. . . ]