User manual PIONEER VSX-521-K

[. . . ] To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the equipment on thick carpet or a bed. D3-4-2-1-7b*_A1_En D3-4-2-1-1_A1_En Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. IMPORTANT: THE MOULDED PLUG This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to BS1362. [. . . ] Press ADAPTER to switch the ADAPTER input, then conduct the pairing operation on the Bluetooth wireless technology device. If pairing is successful, there is no need to performing the pairing operation below. € When using the AS-BT200 only: If the Bluetooth wireless technology device supports SSP (Secure Simple Pairing), there is no need to make the security code setting. Press ADAPTER to switch the ADAPTER input, then conduct the pairing operation on the Bluetooth wireless technology device. If pairing is successful, there is no need to performing the pairing operation below. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by PIONEER CORPORATION is under license. Other trademarks and trade names are those of their respective owners. Español 6 From the Bluetooth wireless technology device list, select Bluetooth ADAPTER and enter the PIN code selected in the step 4. € PIN code may in some case be referred to as PASSKEY. Listening to Music Contents of Bluetooth wireless technology device with Your System 1 Press ADAPTER to switch the receiver to ADAPTER input. High speed tuning Press and hold TUNE / for high speed tuning. Release the button at the frequency you want. 1 Tune to a station you want to memorize. See Listening to the radio above for more on this. Tip • To erase a station name, follow steps 1 and 2, and press ENTER while the display is blank. Press TUNER EDIT while the display is blank, to keep the previous name. € Once you have named a station preset, Press DISP to show the name. When you want to return to the frequency display, press DISP several times to show the frequency. The display shows PRESET, then a blinking MEM and station preset. 3 Press PRESET / to select the station preset you want. The preset number stop blinking and the receiver stores the station. [. . . ] Signals that are input from the HDMI terminal will not output from the analog video terminal. Be consistent with the type of cable between input and output. ρDepending in the output settings of the source component, it may be outputting a video format that can’t be displayed. Change the output settings of the source, or connect using the component or composite jacks. [. . . ]