User manual PIONEER VSX-D711-S

[. . . ] Only multi-voltage model is provided with these switches. mains voltages in Saudi Arabia are 127 V and 220 V only. Never use this model with the 110 V setting in Saudi Arabia. The line voltage selector switches are on the rear panel. [. . . ] The effect automatically adjusts according to the volume at which you're listening. Each press cycles through the effects as follows: Depending on what you are listening to, you may want to adjust the bass or treble using the front panel tone control. Each press switches between BASS and TREBLE. 2 Use the MULTI JOG/INPUT SELECTOR dial to change the amount of bass or treble as necessary. Wait about five seconds for your changes to be input automatically. Use the MULTI CONTROL buttons on the remote (or MULTI JOG/ INPUT SELECTOR dial on the front panel). 4 Start playback of the component you selected in step 1. If you have connected a decoder or a DVD player with multi-channel analog outputs to this receiver (page 17), you must select the analog multi-channel inputs for surround sound playback. To cancel playback from the multichannel inputs, use the SIGNAL SEL (SIGNAL SELECT) button to select a different input signal. When playback from the multichannel inputs is selected, you can't use the INPUT ATT, TONE, and MIDNIGHT/ LOUDNESS buttons, as well as the Standard, Advanced Surround, and Stereo/Direct sound modes. When playback from the multichannel inputs is selected, only the volume and channel levels can be set. To ensure the best possible surround sound, be sure to complete the following set up operations. This is particularly important when using Dolby surround. You only need to make these settings once (unless you change the placement of your current speaker system or add new speakers, etc. Refer to the following pages for details on each of the settings. 3 Use } or ] to choose the option you want to adjust. It will be easiest to adjust each of the settings in turn, following the order below (and on the following pages). The current setting is shown for each option as you cycle through the display. Speaker setting (page 62) Specify the number and type of speakers you have connected. Surround back speaker setting (VSX-D811S only) (page 63) Specify your surround back speaker/surround back subwoofer setup. Crossover frequency setting (page 64) Determine which frequencies will be sent to the subwoofer (or large speakers). lFE attenuator setting (page 65) Specify the peak level for the LFE channel. [. . . ] remedy · Connect the power plug to the wall outlet. Disconnect the power plug from the outlet, and insert again. Make sure there are no loose strands of speaker wire touching the rear panel. This could cause the receiver to shut off automatically. [. . . ]