User manual PIONEER VSX-S520D

[. . . ] 68 E N > Before Start > Part Names > Install > Initial Setup > Playback Advanced Setup | Firmware Update | Others What's in the box Before Start E N Main unit (1) Indoor FM antenna (1) (VSX-S520) Remote controller (RC-933R) (1), batteries (AAA/R03) (2) 0 Connect speakers with 4 Ω to 8 Ω impedance. 0 The power cord must be connected only after all other cable connections are completed. 0 We will not accept responsibility for damage arising from the connection of equipment manufactured by other companies. Furthermore, available services may vary depending on your area of residence. [. . . ] 0 If multiplex audio is being played, "1+1" will be displayed on the display of this unit when on the remote controller is pressed. Set the input channel to use for playing any 2 ch digital source such as Dolby Digital, or 2 ch analog/PCM source in the Mono listening mode. "Left": Left channel only "Right": Right channel only "Left + Right (Default Value)": Left and right channels Source ∫ Input Volume Absorber Adjust the volume level difference between the devices connected to the unit. Set a negative value if the volume of the target device is larger than the others and a positive value if smaller. To check the audio, start playback of the connected device. (Default Value is "0 dB") E N ∫ Name Edit Set an easy name to each input. The set name will be shown on the main unit display. Select a character or symbol with the cursors and press ENTER. Repeat it to input 10 or less characters. "A/a": Switches between upper and lower cases. (Pressing MODE on the remote controller also toggles between upper and lower cases) " " " ": Moves the cursor to the arrow direction. " ": Removes a character on the left of the cursor. 0 Pressing CLEAR on the remote controller will remove all the input characters. After inputting, select "OK" with the cursors and press ENTER. Mono Input Channel ∫ Dolby Loudness Management When playing Dolby TrueHD, enable the dialog normalization function which keeps the volume of dialog at a certain level. Note that when this setting is Off, the DRC function that allows you to enjoy surround at low volumes is fixed to off when playing Dolby Digital Plus/Dolby TrueHD. "On (Default Value)": Use this function "Off": Do not use this function ∫ Volume Volume Limit Headphone Level Set the maximum value to avoid too high volume. select "Off (Default Value)" or a value between "30" and "49". Adjust the output level of the headphones. select a value between "-12 dB" and "+12 dB". (Default Value is "0 dB") 0 To name a preset radio station, press TUNER on the remote controller, select FM/DAB and select the preset number. 0 This cannot be set if the "NET", "USB" or "BT AUDIO" input is selected. [. . . ] C p 3 / d q 4 ; e r 5 : f s 6 @ g t 7 [ h u 8 ] i v 9 j w 0 k x - l y ^ m z \ A/a When finished, select the "OK" key. уя кнопки / (a) на пульте ДУ, выберите "I have a Pandora Account" или "I’m new to Pandora" и нажмите ENTER (b). наки The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. manufactured under license from Dolby Laboratories. [. . . ]