User manual PIONEER VSX932

[. . . ] 28 For details about the Network Functions and listening modes, and information regarding the advanced settings, refer to the "Advanced Manual" available on our website. 0 The power cord must be connected only after all other cable connections are completed. 0 We will not accept responsibility for damage arising from the connection of equipment manufactured by other companies. aM loop antenna (1) 0 Quick Start Guide (1) 0 Basic Manual (This manual) 0 Connect speakers with 4 Ω to 16 Ω impedance. [. . . ] The speakers emit the test tone at high volume during measurement, so be careful of your surroundings. Keep the room as quiet as possible during measurement. 0 If you have connected a subwoofer, check the power and volume of the subwoofer. Set the subwoofer volume to more than halfway. 0 If the power of this unit suddenly turns off, the wires in the speaker cables may have touch the rear panel or other wires and tripped the protection circuit. Twist the wires again properly and make sure they do not stick out of the speaker terminals when connecting. Place the supplied speaker setup microphone in the listening position, and connect to the MCACC SETUP MIC jack on the main unit. "Use iOS Device (iOS7 or later)": Share the iOS device's Wi-Fi settings with this unit. If you select "Scan Networks", there are a further two choices of connection method. "Enter Password": Enter the password (or key) of the access point to connect. "Push Button": If the access point has an automatic connection button, you can connect without entering a password. 0 If the SSID of the access point is not displayed, then in the screen listing the SSIDs, select "Other. " with the cursor on the remote controller and press ENTER, then follow the onscreen instructions. Keyboard Input To switch between upper and lower case, select "A/a" on the screen and press ENTER. To select whether to mask the password with " " or display it in plain text, press +Fav on the remote controller. press CLEAR to delete all the input characters. 0 A confirmation screen asking you to agree to the privacy policy is displayed during network setting. select "Accept" and press ENTER to indicate agreement. The image on the screen changes as you choose the number of channels in "Speaker Channels", so refer to it when performing the settings. Test tones are emitted by the speakers, and firstly the unit detects the speakers connected and the noise in the environment. After the results of the above measurements are displayed, select "Next", press ENTER on the remote controller, and the test tones are emitted again, and the unit automatically makes settings such as the optimum volume level and the crossover frequency. When the measurement is completed, the measurement result is displayed. [. . . ] 0 Depending on the input signal and speaker configuration, the Dolby Surround and DTS Neural:X modes that expand 2 channel and 5. SURR button (c) You can select a variety of listening modes to suit your taste. There are the Dolby Digital, DTS-HD Master Audio, and Stereo modes that you can choose to suit the input signal, or the Dolby Surround and DTS Neural:X modes that can expand 2 channel and 5. You can also enjoy original surround modes such as Ext. [. . . ]