User manual PIONEER XN-M10

[. . . ] Check that it is set properly before plugging the power cord into the outlet. If the voltage is not properly set or if you move to an area where the voltage requirements differ, adjust the selector switch as follows: ¶ Be sure to disconnect the power cord from its outlet before making this adjustment. Use a medium-sized (flat blade) screwdriver. Insert the tip of the screwdriver into the groove of the selector switch and turn it so that the power voltage marking of your area points to the arrow. [. . . ] To select preset numbers over 10, use the >10 button. For easier identification, you can name your station presets. 1 Recall the station preset you want to name. See Listening to station presets on this page for how to do this. Names can be up to 12 characters long and can contain letters (upper and lower case), numbers, spaces and other symbols. If the tuning frequency step is changed (p. 33), or if the system is left disconnected from the AC power outlet for over 4 hours, the station presets will be lost and will have to be reprogrammed. Display shows a underbar where the first character will go. Use numbers keys 1-9 for the corresponding number and the letters shown above each key below. Press a key repeatedly to cycle through the letters (or symbols) on that key. Move the cursor backwards or forwards along the list using 2 and 3. Use the 5 and buttons to switch between character lists: Alphabet (uppercase) - Alphabet (lowercase) numbers (0-9) - symbols 4 Confirm the character and move the underbar to the next character position by pressing ENTER. You can edit preset names after they have been set, or you can erase them completely. Until you press ENTER, then the underbar moves to the next position Move the cursor along the list using 2 and 3 · Move the underbar backwards or forwards along the display using ­. Erase the character one position before the flashing cursor by pressing CLEAR 5 When you've finished editing the name, press MENU to exit. Move the underbar backwards or forwards along the display using ­. Erase the character one position before the flashing cursor by pressing CLEAR 5 When you've finished naming the station preset, press MENU to exit. You can make tape recordings from the radio or a disc loaded in the player, or from an external component connected to the auxiliary inputs. If you're recording from CD it may be more convenient to use synchro recording-- see Automatically recording from a CD starting on the following page. Once recording has started, you can't switch to another component until recording has stopped. So, for example, you can't switch over to the tuner while you're recording a CD. Unlike some tape decks, there's no need to set recording levels; the deck sets the level automatically. [. . . ] Auto tuning will only detect radio stations with a good signal. Check that the volume is turned up, that the speakers are on, the input function set correctly, etc. If the radio signal is weak, an outdoor antenna will usually give better results than the supplied indoor types. Other electrical equipment, such as TVs, fluorescent lamps and motors can cause interference. [. . . ]