User manual PIONEER XR-VS6

[. . . ] · Securely route all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring through places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. [. . . ] This will damage the lead insulation and cause a very dangerous short. If you do, the protection circuit may fail to work when it should. · Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating. · When replacing the fuse, be sure to only use a fuse of the rating prescribed on the fuse holder. · To prevent incorrect connection, the input side of the IP-BUS connector is colored blue, and the output side is colored black. Connect the connectors of the same colors correctly. Connection Diagram Multi-CD player (sold separately) IP-BUS Output Antenna Input Antenna Unit This product Blue IP-BUS cable To safeguard from electromagnetic interference · In order to prevent interference, set the following items as far as possible from this unit, its cables or leads: ­ TV antenna and antenna lead ­ FM, AM antenna and its lead ­ GPS antenna and its lead In addition route each antenna lead as far as possible from other antenna leads. Do not bind them together, lay or route them together, or cross them over each other. Increased interference could lead to TV reception appearing fuzzy. Violet Black IP-BUS Input Power Supply 5 m (16 ft. do not stack with the hide-away TV tuner) as there is the possibility of the XM tuner interferring with the other unit, and causing poor reception. · Install the antenna on as flat a place as possible. · Do not paint the antenna, as this may affect its performance. · Do not place items such as magnetic cards close to the antenna because it has a powerful field of magnetism. · The antenna may be less sensitive when it is snowing. · When installing the antenna with magnet, be careful not to scratch the vehicle body. · Be sure to detach the antenna and place inside the vehicle every time you enter a carwash. If it is left on the outside it may be knocked off and scratch the vehicle body. A Title (English) Installing the Unit Mounting with Brackets Tapping screw (4 × 12 mm) Screw (4 × 6 mm) Car mat or chassis Bracket Drill 2 - 2. 5 mm diameter holes. Installation Installing the Antenna Unit Installation using the magnet of antenna 6 in. (15. 5 cm) Clamp Route the antenna cable When routing the lead inside the trunk Clamps Use clamps to secure the lead where necessary inside the vehicle. [. . . ] Waterproof pad Make sure the waterproof pad contacts the top of the rubber packing. 6 in. (15. 5 cm) Make a U-shaped loop in the lead outside the rubber packing to prevent rainwater from flowing along the lead into the interior of the vehicle. Rubber packing Note: · If the antenna is mounted on the vehicle's roof, it can be installed in positions other than those in the diagram. [. . . ]