User manual PIONEER XV-DV575 (DCS-575)

[. . . ] Also, the use of this remote control may cause other devices to work improperly. ⷠWhen the operating range of the remote becomes too short, replace the batteries. If your listening room is of adequate size, place the speakers as shown in step 3 to achieve the optimum surround sound effect. If you are listening in a fairly small room and a typical surround speaker setup is not possible, see Home theater sound setup in the instruction manual and the Speaker Setup Guide for information on the Front Surround setup option. [. . . ] It can also reduce the life or performance of batteries. When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or damaging the speaker. ⷠDo not connect the supplied speakers with any other amplifier. Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker terminal. If any of the bare speaker wire touches the back panel it may cause the power to cut off as a safety measure. ⷠThe front, center and surround speakers supplied with this system are magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker is installed extremely close to the screen of a television set. If this happens case, turn the power switch of the television set OFF, and turn it ON after 15 min to 30 min. If the problem persists, place the speaker system away from the television set. ⷠThe subwoofer is not magnetically shielded and so should not be placed near a TV or monitor. Magnetic storage media (such as floppy discs and tape or video cassettes) should also not be kept close to the subwoofer. ⷠDo not attach the subwoofer to the wall or ceiling. Connect each speaker using the color-coded speaker cords. Connect the DVD/CD receiver to your TV, then connect the supplied power cord. The colored wire with the color-coded label (above the tabs), then insert the colored wire into the red (+) tab and the other wire with the black (­) tab. This player is equipped with copy protection technology. Do not connect this player to your TV via a VCR using AV cables, as the picture from this player will not appear properly on your TV. When connecting the center speakers, connect the Y-cable dual end to the two center speakers in the same way. These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts. The small lug at the wire-end of the speaker plug should face up or down depending on whether it's being plugged into one of the upper or lower three speaker terminals. [. . . ] Each speaker is provided with a color-coded indicator on the model label on the rear side to assist identification. Align the bracket with the respective upper and lower screw holes as shown in each figure below and fasten the screws securely. This is a standard multichannel surround sound speaker setup for optimal 5. The front left and right speakers should be This setup is ideal when rear surround speaker placement isn't possible or you want to avoid running long speaker cables in your listening area. [. . . ]