User manual PIONEER XV-DV990

[. . . ] Remote control unit Dry cell batteries Boîtier de télécommande (size AA/R6P) x 2 Piles sèches (de type AA/R6P) x 2 Speaker cords / Cordons d'enceintes 5 m x 3 (for center, front L-R speakers) 5 m x 3 (pour enceintes centrale et avant G-D) Plug the L-shaped end of the display cable into the connector on the rear of the display unit (AXX7163). Plug the other end of the display cable into USE ONLY WITH AXX7163 jack on the DVD/CD tuner system. When connecting this system or changing connections, be sure to switch power off and disconnect the power cord from the wall socket. After completing all connections, connect the power cord to the wall socket. [. . . ] The subwoofer can be used laying flat, if you prefer. Speaker cord (supplied) Thread the speaker cord through the base and up through the speaker stand, as shown. See left for how to connect the speaker cord to the speaker terminals. Connecting the speaker cords is easier if you first stick the supplied cord labels on either end of each cord. Incorrect use of batteries may cause leakage or rupture. Always be sure to follow these guidelines: Never mix new and used batteries. Batteries of the same size may have different voltages, depending on brand. Do not mix different brands of batteries. When disposing of used batteries, please comply with governmental regulations or environmental rules that apply in your country or area. The remote control can be used within a range of about 7 meters from the remote sensor of the display unit, and within a 30 degree angle. Twist and pull off the insulation on both ends of each speaker cord. Connect a speaker cord to the terminals on the rear of each speaker, attaching the colored wire to the red terminal and the other wire to the black terminal. Connect the other end of each speaker cord to the speaker terminals on the rear of the subwoofer. Make sure that each speaker is connected to its correct pair of speaker terminals. For correct sound, the colored wire should be connected to the red terminal; the other wire to the black terminal. Push the speaker terminal tab to open; insert the exposed wire, making sure there are no stray strands. To prevent battery leakage, remove the batteries when not using the remote control for an extended period (one month or more). If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries with new ones. [. . . ] Connect the power cord to a wall socket. This system's speakers are magnetically shielded (JEITA), so there's virtually no picture color distortion when they are placed near a TV. In the rare event that there is some picture color interference, switch power to the TV off, and wait 15 to 30 minutes before switching on again. Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen. [. . . ]