User manual PIONEER XW-NAC3-R

[. . . ] Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. , 230 V or 120 V) written on the bottom panel. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc. [. . . ] Keep in mind the following when using the remote control: · Make sure that there are no obstacles between the remote and the remote sensor on the unit. ⷠRemote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit's remote sensor. ⷠRemote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit. ⷠReplace the batteries when you notice a fall off in the operating range of the remote. 1 Plug the supplied power cord into the AC IN socket on the back of the unit. 2 Plug the other end into a power outlet. When installing this unit, make sure to put it on a level and stable surface. Don't install it on the following places: ­ on a color TV (the screen may distort) ­ near a cassette deck (or close to a device that gives off a magnetic field). Before making or changing any connections, switch off the power and disconnect the power cord from the AC outlet. 4 Playback control buttons Use when operating an iPod or Bluetooth wireless technology device with this remote control (page 10, 14). 1 Caution · Before making or changing the connections, switch off the power and disconnect the power cord from the power outlet. Adjust the video output on this unit in accordance with the method used to connect the television. When step 2 is repeated again, the iPod indicator will flash one time, and the video output will switch to Composite. When the iPod is disconnected from this unit, the iPod's TV output setting returns to its original state. During the video output setting process, if no button operation is performed for 3 minutes, the setting will be canceled and power will return to the standby mode. When your iPod is connected to this unit and you wish to operate the iPod by touching it directly, be sure to hold the iPod steady with the other hand to prevent malfunctions due to faulty contacts. When an iPod is connected to this unit, iPod indicator will flash while the unit confirms the iPod connection and retrieves data from the iPod. When INPUT is pressed to change the input to iPod, the connection is completed and iPod indicator will light steadily. 1 Playback and volume level setting for iPod music and images can be performed from this unit or the iPod itself. ⷠWhen using the iPod to adjust sound volume, the adjustment will be applied only to the sound produced from this unit's speakers. 2 If the iPod is disconnected from this unit, the iPod's sound volume will return to its original setting. [. . . ] 2 · It must be necessary that the Bluetooth wireless technology enabled device supports AVRCP profiles. "Pairing" must be done before you start playback of Bluetooth wireless technology content using Bluetooth ADAPTER. Make sure to perform pairing first time you operate the system or any time pairing data is cleared. "Pairing" is the step necessary to register Bluetooth wireless technology device to enable Bluetooth communications. [. . . ]