User manual PIONEER XW-NAS5

[. . . ] Make sure it is properly disposed of after removal. The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time (for example, when D3-4-2-2-1a_A_En on vacation). Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product, and to protect it from overheating. To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the D3-4-2-1-7b_A_En equipment on thick carpet or a bed. [. . . ] 3 Connect the SURROUND INPUT on the signal converter to the surround speaker terminals on the AV receiver (VSX-D514) , using the supplied red/black speaker cords. 4 Connect the WIRELESS IN L/R jacks on the transmitter to the OUT L/R jacks on the front panel of the signal converter, using the supplied RCA stereo cord. 5 Connect the supplied AC adapter to the DC IN inlet on the rear panel of the transmitter, then plug into a power outlet. 6 Plug the system and wireless speaker AC power cords into a power outlet. Insert the red wire into the red (+) tab and the black wire into the black (-) tab. Where you put your speakers in the room has a big effect on the quality of the sound. The following guidelines should help you to get the best sound from your system. The illustration below shows a typical speaker setup using the wireless speaker for multichannel sound. Ideally, the other speakers should be at about ear-level when you're listening to them. Putting the speakers on the floor (except the subwoofer), or mounting them very high on a wall is not recommended. For the best stereo effect, place the front speakers 2­3 m apart, at equal distance from the TV. If the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water and wrung out well, then wipe again with a dry cloth. Never use thinners, benzine or insecticide sprays or other chemicals on or near this unit since they will corrode the surfaces. If you use a chemical-impregnated cleaning cloth, read the instructions carefully before use. These cloths may leave smear marks on half-mirror finish surfaces; if this happens, finish with a dry cloth. Use in a place exposed to high temperatures or humidity, including near radiators and other heat-generating appliances. Place on a window sill or other place where the unit will be exposed to direct sunlight. Place directly on top of an amplifier, or other component in your stereo system that becomes hot in use. Use near a television or monitor as you may experience interference--especially if the television uses an indoor antenna. Use in a kitchen or other room where the unit may be exposed to smoke or steam. Use on a thick rug or carpet, or cover with cloth--this may prevent proper cooling of the unit. Place on an unstable surface, or one that is not large enough to support all four of the unit's feet. [. . . ] 4GHz radio wave frequency, which is a band used by other wireless systems (see list below). To prevent noise or interrupted communication, do not use this system nearby such devices, or make sure these devices are switched off during use. You can also try switching the channel on the transmitter (See "Transmitter" on page 11) for better reception. Use of this equipment is limited to home use. [. . . ]