User manual PIONEER XWPSS02-S (MT-01)

[. . . ] Do not put large or heavy objects on top of the speaker. â· Do not install your speakers overhead on the ceiling or wall. â· Do not attach these speakers to the wall or ceiling. â· Keep the speaker away from water and moisture. [. . . ] IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows ; The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED. How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse. With normal use, wiping with a dry cloth should be sufficient to keep the cabinet clean. If necessary, clean with a cloth dipped in a neutral cleanser diluted five or six times with water, and wrung out well. Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit since these will corrode the surfaces. However, depending on the installation location, color distortion may occur if the speaker system is installed extremely close to the screen of a television set. If this happens, turn off the television, then turn it on again after 15 min to 30 min. If the problem persists, place the speaker system away from the television set. When the speaker is used as an optional speaker with the Power Line Sound Station, it is necessary to assign it an ID in order for the system to work properly. Plug the Power Line Sound Station and the Speaker into two AC power sockets. The power sockets should be as close as possible to one another, ideally on the same outlet. The speaker ID setting is confirmed when the motion sensor finishes flashing and lights steadily. Please refer to the troubleshooting guide in the XW-PSS01 operating instructions if you experience problems with the operation of this unit. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. Using this system, you can listen to sound sources from the Power Line Sound Station simply by plugging the power cord into an AC outlet in your home. For example, you could place the Power Line Sound Station in the living room of your house, then set up separate speakers in your kitchen, hallway and bedroom to listen to music wherever you want in your home. â· This optional XW-PSS02-S speaker, you can take advantage of the built-in motion detector to start USB playback when anyone passes by. [. . . ] CAUTION The Standby/On switch on this unit will not completely shut off all power from the AC outlet. Since the power cord serves as the main disconnect device for the unit, you will need to unplug it from the AC outlet to shut down all power. Therefore, make sure the unit has been installed so that the power cord can be easily unplugged from the AC outlet in case of an accident. To avoid fire hazard, the power cord should also be unplugged from the AC outlet when left unused for a long period of time D3-4-2-2-2a_A_En (for example, when on vacation). [. . . ]