User manual PITSOS DGS6728

[. . . ] HQ 2SHUDWLQJ LQVWUXFWLRQV 'LVKZDVKHU $%& 5HVHW VHF 6WDUW 5HVHW VHF en Table of contents Washing the dishes . Switching off automatically after the end of the programme . Protection against frost (Emptying the appliance) . 15 15 15 15 16 16 16 16 16 17 17 17 17 18 18 18 18 19 19 20 20 20 20 21 21 22 23 23 23 24 24 24 24 25 25 25 26 26 26 26 26 Safety instructions . [. . . ] ­ Hold down programme button # and press START button P until : . . . The LED for button # flashes and the digital display )" displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display )". To change the setting: ­ Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). : Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press button @ + until the digital display )" jumps to : . ­ Press @ + or ­ button until the displayed time corresponds with your requirements. ­ Press START button P, timer programming is activated. ­ To delete timer programming, press the @ + or ­ button until )" : is indicated on the digital display. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the value : is indicated on the numerical display )". Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. 16 en ã=Warning Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Close the door. ­ Hold down programme button # and press START button P until the digital display )" : . . . The LED for button # flashes and the digital display )" displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display )". To change the setting, ­ Press the button 3 to switch the Intensive drying on : or off : . The set value is saved. At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. [. . . ] ­ A power cord extension may be purchased from customer service only. ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. ­ The appliance features a water damage protection system. [. . . ]