User manual PITSOS DIS4315

[. . . ] en Operating instructions 9000 510 606 (8906) Dishwasher Reset 3 sec. 11 10 9 8 End Start 1 2 3 4 9h 6h 3h 6 7 5 20 21 22 23 24 25 26 27 28 29 30 31 32 en Table of contents Washing the dishes . 15 15 15 15 15 16 16 16 16 16 16 17 17 17 17 18 18 19 19 19 20 20 21 22 22 22 22 23 23 23 23 23 24 24 24 24 24 Safety instructions . 7 Switching off water softening system . 8 Switching off rinse-aid refill indicator . [. . . ] ­ Press START button @, timer programming is activated. selection at any time until the programme starts. ¿ Extra drying * An increased temperature during the final rinse and an extended drying phase ensure that even plastic parts dry better. There is a slight increase in the energy consumption. ­ To delete the preselected starting time, keep pressing the Preselected starting time button H until none of the displays 3h, 6h or 9h is lit. You can change your programme 15 en End of programme The programme has ended when the End display )" is lit. Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Close the door. ­ Press and hold down the START button @. ­ Rotate programme selector 8 until the "Check water supply" display h flashes. To change the setting, ­ By rotating the programme selector 8, you can switch on intensive drying (End display)" is lit) or switch off intensive drying (End display )" is not lit). The setting is saved. Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. Terminating the programme (Reset) ­ Press START button @ for approx. ­ The remaining programme sequence lasts approx. Switch off ON/OFF switch (. Changing the programme When the START button @ has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). 16 en Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Filters The filters 1R keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. The filter system consists of a coarse filter, a flat fine filter and a microfilter. [. . . ] ­ Disconnect the appliance from the power supply. ­ Disconnect the waste water and fresh water connections. ­ Loosen the fastening screws under the worktop. ­ Pull out the appliance, carefully pulling the hose behind. 23 en Transportation Empty the dishwasher and secure loose parts. [. . . ]