User manual PITSOS POWERJET4

[. . . ] en Operating instructions 9000 439 036 (8908) Dishwasher Reset 3 sec. 10 9 8 7 End Start 1 2 3 9h 6h 3h 5 6 4 20 21 22 23 24 25 26 27 28 en Table of contents Washing the dishes . Protection against frost (Emptying the appliance) . 13 13 13 13 14 14 14 14 14 14 14 15 15 15 15 16 16 17 17 17 18 18 19 19 19 20 20 20 20 20 20 21 21 21 21 21 21 Safety instructions . 7 Switching off water softening system . [. . . ] The only way a programme can be changed is by Cancel programme (Reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Close the door. ­ Press and hold down the START button 8. ­ Rotate programme selector 0 until the "Check water supply" display ` flashes. To change the setting, ­ By rotating the programme selector 0, you can switch on intensive drying (End displayh is lit) or switch off intensive drying (End display h is not lit). The setting is saved. End of programme The programme has ended when the End display h is lit. Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. 14 en Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Filters The filters 1* keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. The filter system consists of a coarse filter, a flat fine filter and a microfilter. ­ After each washing cycle check the filters for residue. ­ Unscrew filter cylinder as illustrated and take out filter system. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. ­ Regularly clean door seal with a damp cloth. [. . . ] Please note the system will not function unless the power supply is connected. Installation The required installation dimensions can be found in the installation instructions. Ensure that the appliance is situated securely on the floor. ­ The appliance can easily be installed in a fitted kitchen between wooden and plastic walls. If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions. Waste-water connection ­ The required work sequence can be found in the installation instructions. [. . . ]