User manual PLANAR CT1905S Product Manual

[. . . ] PLANAR LCD MONITOR CT1905S MANUAL www. planar. com Planar User's Manual PREFACE FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. FCC WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Power Switch Powers the monitor ON or OFF. USB Hub Connect the USB cable from this port to PC HOST. Up to 4 devices may be connected through this hub. 2. 3. 4. 6. Adjusting the Viewing Angle Your LCD Monitor can be adjusted both horizontally and vertically. Connecting AC Power Plug the female end of the power cable into the AC power connector. Plug the male end of the power cord into a wall socket. The plug on the power cable will vary according to the electrical standard in your area. 3 Chapter 1 Connecting Video 1. Before connecting your monitor to the PC, please power-off both devices. Connect one end of the VGA signal cable to the PC's 15-pin VGA port and the other end to the monitor 15pin VGA port. 3. 4. Connect one end of the DVI signal cable to the PC's 24-pin DVI port and the other end to the monitor 24-pin DVI port. Make sure the signal cables are securely connected to both the monitor and PC. Tighten the connecting screws to ensure a secure connection. If both analog (15-pin D-sub VGA) and digital (24-pin DVI) input ports are connected at the same time, the signal input can be selected with the port select button. Please go to the next chapter for details. Connecting the Stereo Speakers 1. Connect the 1. 5M audio cable to the Line-OUT of your PC's audio card. Connect the opposite end of the 1. 5M audio cable to the LCD Monitor's line-IN connector. 4 Planar User's Manual Connecting the Optional Touch Screen Your LCD Monitor has an optional touch screen feature. Use the FUNCTION select buttons to scroll between the submenu items Contrast: Use the Adjust keys to adjust the difference between the lightest and darkest areas on the display. The contrast level can range from 0 to 63. Brightness: Use the Adjust keys to adjust the intensity of the monitor backlight. Speaker Volume: Use the Adjust Graph/Text: Use the Adjust to change between DOS graphic 640x400 or 720x400. This function is not used within MS Windows. Auto Adjust: While the Auto-Adjust sub-menu is selected, press the Adjust key to activate the Auto Adjust procedure. The Auto Adjust procedure takes approximately 2 seconds to complete. Once finished, the OSD menu will disappear after a short time-out period. [. . . ] (Or you can the select window shut down screen) After you have the wallpaper loaded, open the OSD and select the "Clock" function. Press the top (or bottom) Adjustment Control button and continue pressing the button until you see vertical dark and light lines across the screen. When you can see distinct light and dark vertical bands, stop pressing the Adjustment Control button. Now press the opposite (top or bottom) Adjustment Control button. [. . . ]