User manual PLANAR LA1950R

[. . . ] LA1950RTR / LA1950RTC LA1950RTS / LA1950R Touch Screen LCD Monitor USER'S GUIDE www. planartouch. com The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. Nopart of this document may be reproduced, translated to another language or stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission. Windows is a registered trademark of Microsoft, Inc. [. . . ] Connect the D-SUB cable from the display's VGA input connector to the D-SUB connector of your host computer and tighten the screws (10. 1). Connect the RS-232 or USB cable from the RS-232 or USB port of your display to the RS-232 port (10. 1) or USB port (10. 1) of your computer. Refer to the "Touch Screen Driver Installation" section on page 18. Once the touch screen is configured, the monitor is ready for use. Connect the remote control cable to RJ11 port (10. 1) (optional). ! Notice! To ensure the LCD display works well with your computer, please configure the display mode of your graphics card to make it less than or equal to 1280 x1024 resolution and make sure the timing of the display mode is compatible with the LCD display. We have listed the compatible "Video Modes" of your LCD display in the appendix (on page 17) for your reference. Don't connect telephone or internet cable to RJ-11 port. Adapter rating:12Vdc 4A min. , marked with LPS. 9 (Figure 10. 1) LA1950RTR / LA1950RTC / LA1950RTS LA1950R 10 User Controls Back Panel Controls Power Enter Down Up Menu OSD Key Menu off status Menu appear Brightness Contrast Menu on status Menu disappear/return to main item Main item select up/Adjust up Main item select down/Adjust down Enter/Select sub-item function Power On/Off 11 How to Use the OSD Menus Icon key Name Menu Up Down Enter Power 1. Press the "MENU" button to pop up the "on-screen menu" and press "Up" or "Down" button to select among the five functions in the main menus. Choose the adjustment items by pressing the "Enter " button. Adjust the value of the adjustment items by pressing the "Up" or "Down" button. With the OSD menu on screen, press " Menu" button to return main menu or exit OSD. The OSD menu will automatically close, if you have left it idle for a pre-set time. To Lock the OSD / Power menu buttons, please follow the instructions below. (Please note: the monitor has to be turned ON with a valid signal preset) (a. ) Press "Menu" key , the OSD menu will pops upon display. (b. ) Press and hold the "Menu" key again with the OSD menu on the screen, the OSD menu will disappear. Then press the "Power" key 1 time while the menu key is still being pressed. The "Lock/Unlock" menu will appear for 3 seconds. If the problem persists, please contact your local dealer or our service center. Check that all the I/O and power connectors are correctly and well connected described in the "Installation" section. Make sure the pins of the connectors are not crooked or broken. Problem: Partial Image or incorrectly displayed image. [. . . ] Make sure that the RS232 or USB cable is connected to the computer. If your EWF is enabled, please disable the EWF by using the EWF Manager command. Once the EWF is disabled, download the driver online and execute. Click on the XP driver and follow the step-by-step instructions as shown on the pop-up windows. Custom: 1. [. . . ]