User manual PLANAR LED2210MW

[. . . ] LED2210MW The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. No part of this document may be reproduced, translated to another language or stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission. Windows is a registered trademark of Microsoft Inc. [. . . ] Lay the monitor flat on a table with front face down. Press and hold the hooks inside, and pull the stand-base. 88 INSTALLATION INSTRUCTIONS Power Source: 1. Make sure that the power cord is the correct type required in your area. CABLE CONNECTIONS Connecting the Signal Cable: Plug one end of the signal cable to the LCD monitor and the other end to a computer or a video source. Connecting the Power Cord: Plug the AC power cord one end to LCD monitor's AC-power AC input socket , the other end to Wall outlet. Connecting the Audio Cable: Connect the audio cable between the monitor's audio input and the PC's audio output. Caution: If the AC outlet is not grounded (with three holes), install the proper grounding adapter (not supplied). Figure 1 1. 4 Connecting Cables AC Power Cord DP Cable D-Sub Cable Sub Audio Cable 9 ADJUSTING THE VIEWING ANGLE For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor's angle to your own preference. Hold the stand so you do not topple the monitor when you change the monitor's angle. You are able to adjust the monitor's angle from -5 to 19. Figure 2 NOTES Do not touch the LCD screen when you change the angle. It may cause damage or break the LCD screen. Careful attention is required not to catch your fingers or hands when you change the angle. 10 OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located at front panel of the monitor (See Figure 4). By changing these settings, the picture can be adjusted to your personal preferences. The power cord should be connected. Connect the video cable from the monitor to the video card. Press the power button to turn on the monitor. The power indicator will light up. Figure 3 External Control Button EXTERNAL CONTROLS 1. Source/Auto Adjust/EXIT ECO (-) Power Indicator Power Indicator Volume Hotkey(+) MENU/ENTER Power Button 11 FRONT PANEL CONTROL Power Button: Power Indicator : Press this button to switch ON/OFF monitor's power. Blue --- Power On mode. MENU/ENTER: Activates OSD menu or function adjust confirm. ECO/(-) Activates the ECO control when the OSD is OFF or navigate through adjustment icons when OSD is ON or adjust a function when function is activated. Volume/+: Activates the volume control when the OSD is OFF or navigate through adjustment icons when OSD is ON or adjust a function when function is activated. Source/Auto Adjust/Exit: When the OSD is OFF, pressing Auto/Source button will toggle between sources. Press continuously to select the input source indicated in the message bar. Press Menu/Enter button to change to the selected source. Auto configure hot key :(VGA input only) When the OSD is OFF, press and hold down the button for 2 seconds to auto configure. [. . . ] *Make sure computer is operational by hitting the CAPS LOCK key on the keyboard while observing the CAPS LOCK LED. The LED should either turn ON or OFF after hitting the CAPS LOCK key. Missing one of the primary colors (RED, GREEN, or BLUE) Screen image is not centered or sized properly. Picture has color defects (white does not look white) Horizontal or vertical disturbances on the screen *Use win 95/98 shut-down mode Adjust CLOCK and FOCUS or perform hot- key (AUTO-key). [. . . ]