User manual PLANAR PT1814NUV Product Manual

[. . . ] PLANAR LCD MONITOR PT1814NUV MANUAL www. planar. com Preface PREFACE FCC Compliance Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] The VESA DPMS proposal provides four phases of power saving modes by detecting the horizontal or vertical sync signal. When the LCD Monitor is in power saving mode or detects an incorrect timing, the Monitor screen will go blank, and the power LED indicator will start to blink. 6 CHAPTER 2 The Display Controls The LCD Monitor's Display Controls This chapter covers the LCD Monitor's On Screen Display (OSD). Using the OSD you can adjust the contrast, brightness, display position, display clarity, and color temperature, etc. You can also adjust the stereo speaker volume and set OSD parameters. Please read this chapter carefully to get the most out of your LCD Monitor. Adjusting the Monitor's Display The LCD monitor features an intuitive, menu-driven, On-Screen Display (OSD). You can access the OSD any time that the PC is powered up. If the PC is in a power saving mode, or is powered down, the OSD is inaccessible. NCTION DJUST ENU OSD Main Menu To activate the OSD Main Menu, press the MENU key. To navigate the topline menu, use either the down or up function keys to scroll between the main menu choices. The option that is currently selected is highlighted in red and indicated by a pointer. Each main menu has an associated submenu and is further described. Main Menu BASIC SETTING POSITION AUTO-ADJUST COLOR TEMP. MISCELLANEOUS VIDEO LANGUAGE INPUT PORT RESET EXIT Control contrast, brightness, video level, and Gamma, etc. To control the display size, position, clock and phase, etc. To automatically adjust the picture quality and alignment. To control audio volume, OSD positions and to give current display mode information. For S-Video or CVBS input mode selection (optional) To select different OSD text language. To select input signal sources between PORT1 (VGA) and PORT2 (Digital DVI). To reset the display parameters to the factory default values. Exit OSD Menu. 7 User's Manual Basic Setting CONTRAST BRIGHTNESS VIDEO LEVEL GAMMA FRAME TO MAIN MENU To adjust the contrast level of the display. To adjust the brightness level of the display. Fine tuning the input signal voltage level. Perform this function whenever the PC graphic card is changed. [. . . ] Please change to an alternate mode listed in Appendix B or replace the VGA card and repeat steps 1 and 2. If the PC (or Notebook PC) doesn't function with the CRT monitor neither, check BIOS to see if there is a Simultaneous Display setting under the display mode item. Set the BIOS display mode to Simultaneous Display or CRT and try again. If there is still no display, then there may be a problem with your system. [. . . ]