User manual PLANET BIKE 1200XR

[. . . ] 2 watt NiMH rechargeable headlight TOP SWITCH Press and hold for ON\OFF, Press and release for HIGH-LOW beam BATTERY INDICATOR LED CHARGER PORT (Covered by rubber seal) MAIN ON/OFF *LEAVE "ON" WHILE CHARGING BATTERY CHARGER (AC ADAPTER) CHARGER JACK Intellicharging the Battery 1) Turn MAIN power switch to "ON" position. 2) Plug the charger jack into the charger port on the side of the light after removing the rubber seal. [. . . ] When the MAIN power is OFF the battery will continually charge without shutoff and this will reduce the life of the battery. WARNING: * The recharging unit is for indoor use only and is designed only for use with this lighting system. * The battery and the charger will become warm during charging. If either becomes too hot to touch, discontinue charging and contact your dealer. PRECAUTION: * The Intellicharger charges approximately 8 hours before reverting to "pulse" charging. Any disruption of power to the Intellicharger will reset the charging cycle. * If the battery is not used for a long period of time, charge it once every three months to maintain the life of the Nickel Metal Hydride (NiMH) battery. * To ensure maximum run time, make sure your batteries are fully charged before use. * During long periods of non use, unplug the charger from the light. Operating the Light 1) Turn the MAIN power switch on the back of light to the "ON" position. [. . . ] QuickCamTM Bracket Installation 1) Wrap bracket clamp around handlebar as shown in diagram. 2) Adjust bracket clamp tension on handlebar by rotating cam lever clockwise to tighten and counterclockwise to loosen (as shown in diagram to left). CLOSED OPEN ADJUST Part # 3006 [. . . ]