User manual PLANET BIKE ALIAS SC 15 WATT

[. . . ] Do not attempt to open it as it can damage the unit and voids the warranty. * To ensure maximum run-time, make sure the battery is fully charged before use. * If the battery is not used for a long period of time, charge it once every three months to maintain the life of the Nickel Metal Hydride (NiMH) battery. * During long periods of non-use, make sure the charger and battery cables are unplugged from the battery pack. [. . . ] Contact your Local Bike Dealer or Planet Bike for more details. This product is not intended to replace your bicycle's reflectors. The reflectors on your bicycle should never be removed. Bicycling in the dark is an inherently dangerous activity and no lighting system or reflectors will protect you from either road hazards or inattentive motorists. Common sense and caution should always be exercised, including the use of helmets and reflective clothing. Planet Bike Po Box 259267 Madison, WI 53725 www. planetbike. com ©2002. All Rights Reserved. CHARGER PORT BATTERY PACK CHARGER CHARGING INDICATOR LED RED LIGHT = Charger is plugged in GREEN LIGHT = Battery is charging CHARGER JACK CD 16 mm SCREW QUICK RELEASE LEVER BRACKET CLAMP POWER PLUG BATTERY PACK REMOTE SWITCH BOX SUPERCIRCUIT CONTROL BOX LIGHT HEAD 8 mm SCREW FLASHING GREEN = Battery is fully charged Intellicharging the Battery The battery has been partially charged after production. It is recommended that the battery be fully recharged before use. The CHARGING INDICATOR LED lights up red. 2) Plug the CHARGER JACK into the CHARGER PORT on the side of the battery. The CHARGING INDICATOR LED lights up green indicating the unit is charging. Charge the battery until CHARGING INDICATOR LED is blinking green indicating the battery is fully charged (Approximately 10 hours). 3) The Intellicharger feature allows you to leave the battery plugged in full time. The battery charges fully and shuts off when full charge is achieved. Intellicharger then keeps your battery fully "topped-off" by "pulse" charging the battery for a few seconds each minute to maintain a full charge without risking battery damage. Note: See Warnings and Precautions on page 1-A. Mounting Instructions 1) Loosen the 16 mm SCREW on the bracket side of LIGHT HEAD. (You can attach the bracket to either side of the light head by removing and exchanging positions of the 16 mm and 8 mm length screws. ) Rotate light head to a desired position. See MOUNTING POSITION OPTIONS diagram below. Once you have determined a position, tighten the 16 mm SCREW into the bracket and light head. (NOTE: It is important to use both screws in order for the light case to seal tightly) 2) Wrap BRACKET CLAMP around the handlebar close to the handlebar stem. Adjust QUICK RELEASE clamp tension on the bar by rotating the LEVER clockwise to tighten or counterclockwise to loosen. [. . . ] 2) To turn the light on, press and hold the REMOTE SWITCH for 1-2 seconds. 3) To change power settings, press and release the REMOTE SWITCH. The switch will change in the order of: low, medium, high, flashing and then back to low power with each click of the REMOTE SWITCH. 4) To turn the light off, press and hold the REMOTE SWITCH for 1-2 seconds. [. . . ]