User manual PLANET BIKE INSIGHT 15 WATT

[. . . ] · Check cable connections to the light case and power cable. · Check for damaged wires, switch, bulb or battery. · Recharge battery to full power. [. . . ] Note: The main POWER SWITCH on the top of the battery can be in either the on or off position during charging. 3) The Intellicharger feature allows you to leave the battery plugged in full time. The battery charges fully and shuts off when full charge is achieved. Intellicharger then keeps your battery fully "topped-off" by "pulse" charging the battery for a few seconds each minute to maintain a full charge without risking battery damage. WARNINGS AND PRECAUTIONS: * The Intellicharger charges approximately 12 hours before reverting to "pulse" charging. Any disruption of power to the Intellicharger will reset the charging cycle. * The recharging unit is for indoor use only and is designed only for use with this lighting system. * The battery and the charger will become warm during charging. If either becomes too hot to touch, discontinue charging and contact your dealer. * Disconnect the battery cable from the light head during non use to avoid accidental light activation and possible fire hazard from heat of the bulb. * The water bottle battery is a sealed unit. Do not attempt to open the bottle cap as it can damage the unit and voids the warranty. * To ensure maximum run-time, make sure your battery is fully charged before use. * If the battery is not used for a long period of time, charge it once every three months to maintain the life of the Nickel Metal Hydride (NiMH) battery. * During long periods of non-use, unplug the charger from the battery pack. Operating the Light 1) Turn on the battery POWER SWITCH on top of the water bottle battery. The POWER LED will light up red when the power is on. After switching the power on, the headlamp will be illuminated for the first 3 seconds while the system checks the current power reserve. 2) To turn the light on, press and hold the REMOTE SWITCH for 1-2 seconds. [. . . ] 2) Adjust QUICK RELEASE clamp tension on the bar by rotating the LEVER clockwise to tighten or counterclockwise to loosen. Ideal tension allows for the light beam to be adjusted up or down by pushing the light case with your hand. 4) Insert POWER CORD PLUG into light case receptacle and battery pack. [. . . ]