User manual PLANTRONICS 220

[. . . ] Turn headset on (hold call control button for 2 seconds until the light flashes blue) and it will automatically go into pairing mode, flashing red and blue. NOTE: Normally you only need to pair the headset and handset once. If headset has been previously paired with another device, follow pairing instructions on the next page. EN PAIRING If headset has previously been paired with another device, please follow these instructions for pairing a second time. [. . . ] Using Voice Dialling With the headset on, press the call control button for 2 seconds to activate the voice dialling. NOTE To use voice activated dialing, the voice dialling feature must be enabled on your phone. See your Bluetooth phone manual for instructions. Rejecting a Call When receiving an incoming call, press the call control button for 2 seconds to reject the call. Switching a Call From Phone to Headset To switch an active call from your phone to your headset, press the call control button for 3 seconds. Switching a Call From Headset to Phone To switch an active call from your headset to your phone, press the call control button for 2 seconds. EN INDICATORLIGHTS Headset Status Powering on Powering off Charging battery Low battery Pairing mode Missed call Ringing Headset Indicator Light Blue flashes. Single press the call control button to cancel. Briefly press call control button to answer the call. Press call control button for 2 seconds to reject the call. EN ACCESSORIES Available for purchase To order, please contact your Plantronics supplier or go to www. EN TROUBLESHOOTING PROBLEM My headset does not work with my phone. SOLUTION Headset was not in pairing mode when mobile phone menu selections were made. see page 6 "Bluetooth Pairing". Incorrect menu selections were made on your mobile phone. Incorrect menu selections were made on your mobile phone. Callers cannot hear me, or I cannot hear caller/dialling tone. Press the call control button for 2 seconds until you hear a beep or see the indicator light glow blue to turn headset on. Move the headset closer to the phone or Bluetooth device. Charge your battery using the AC power adapter supplied. Press the volume key up (toward the ear loop) to increase the sound heard in the headset. Press the call control button for 2 seconds until you hear a beep or see the indicator light glow blue to turn headset on. [. . . ] To comply with FCC RF exposure requirements, only use supplied antenna. Any unauthorized modification to the antenna or device could void the user's authority to operate this device. INDUSTRY CANADA NOTICE Radio Equipment The term "IC:" before the radio certification number only signifies that Industry Canada technical specifications were met. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. [. . . ]