User manual PLANTRONICS AVAYA AWH75N DECLARATION OF CONFORMITY

[. . . ] Plug the AC power adapter into the bottom of the Calisto base, and then plug it into an available wall outlet. Route the AC power adapter cable under the cable holder as shown. Plug one end of the telephone cable into the Calisto base and the other end into an available wall telephone jack. If needed, use the splitter included to share the wall jack with another device. * 5. [. . . ] Slide the battery cover onto the handset and place the handset onto the base to charge it. The screen may take up to 10 minutes to show charge indicator. 2 3 Wearing the Headset 1. The headset can be worn on your left or right ear. To switch from one ear to the other, flip the ear loop to the side, and twist around as shown. Placing Calls The headset must remain within 33 feet of the handset in order to place or receive a call on the headset. Calls can also be placed from the headset or speakerphone when the handset is in the charging base. For your convenience, the headset comes pre-paired with the Calisto phone. To place a call using: Handset Do the following: Dial the number and then press the Talk key. After you hear a dial tone, dial the number. key. 2. The ear tip should fit comfortably in the opening of your ear canal. It may take some adjusting to find a comfortable and secure fit. Point the mouthpiece toward your mouth. Speakerphone Headset key. You can also refer to the Plantronics Web site to see if there are instructions specific to your mobile phone www. plantronics. com/easytopair Once the headset and mobile phone are paired, you can use the headset with both the Calisto and your mobile phone. You only need to pair the headset with your mobile phone once. Before you begin, make sure your mobile phone is Bluetooth compatible. You may need to refer to the user's guide for your mobile phone to find out this information. While wearing the headset, turn it off by holding down the Headset button for 4 seconds, until you hear 4 descending beeps. Refer to your mobile phone's user's manual for specific instructions about activating Bluetooth pairing. While your mobile phone is searching for Bluetooth devices, hold down the Headset button on the headset for 4 to 6 seconds until the light on the headset flashes red and blue. When the mobile phone detects the headset, select Calisto PLT from list of found devices. When mobile phone prompts you for a passcode, enter "0000" on the mobile keypad as shown. Receiving Calls When your mobile phone rings, press the Headset button on the headset for under 1 second or until you hear a single high beep to answer the call. Note that your headset must be within 33 feet of your mobile phone. Some mobile phones require you to accept the headset connection each time you receive a call on the headset. Ending Calls Press headset button to end the call, or end the call using your mobile phone. If you are using the headset, press the Headset button inward for under 1 second to end call. Your headset is now paired with your mobile phone and works within 33 feet of your mobile phone. tIP When using the headset with your mobile phone for the first time, it is recommended that you do it out of range from the Calisto handset and base. [. . . ] is not displayed on screen, press headset button for under If 1 second. You should hear a beep in the headset and then the phone dial tone. If issue continues, see comprehensive User Guide for instructions on how to re-pair headset with Calisto handset. Can't pair headset with my mobile phone Make sure that your mobile phone is Bluetooth enabled. [. . . ]