User manual PLANTRONICS CA10

[. . . ] CA 10_1 Owner Registration PLEASE COMPLETE YOUR OWNER REGISTRATION NOW AND MAIL TO PLANTRONICS. This is not a condition for warranty service, but will assist us in providing warranty service and technical support for the product. Mr. Miss First Name Last Name 12/12/01 3:46 PM Company (If applicable) Page 1 Address City State Zip Phone (Day) Ext. Phone (Night) Date of Purchase month day year email address Place of purchase/store name: CA10 Fold Here Fold Here Fold Here 1) Product acquired for use in: (Check one) 5) Please indicate the age and gender of the Fold Here Fold Here Fold Here 1) Product acquired for use in: (Check one) 5) Please indicate the age and gender of the primary user (for classification purposes only): 1 CA 10_1 2 Age: 1 3 2 3 4 4 Home/home office A call center An office outside the home Other Under 18 18-39 2 40-49 50 & over Female 2) How many people are employed at the primary work location/business address of the user? 1 Gender: 12/12/01 Male 1 1-19 6) Are you the primary user of this product? 1 4 6 3 5 2 3:46 PM 20-99 Yes 2 100-249 250-499 No 7) Plantronics or our affiliates may choose to contact you to request feedback or offer you 500-999 1, 000+ 3) Approximately how many hours per day does the user spend on the telephone for: Work: 1 3 5 Page 2 8+ hrs you prefer 1 2 3 product information on products or services we think may be of interest to you. Please specify if 2 0-1 hr 2-3 hrs 4 3 5 4-5 hrs 6-7 hrs 8+ hrs 4 5 Personal: 1 2 not to be contacted (check all that apply). 0-1 hr 2-3 hrs 4 4-5 hrs 6-7 hrs one) 4) Will this product be used primarily for:(Check 1 3 By email By mail By telephone Do not contact me Do not allow your affiliates to contact me or both 2 Business use Personal use Thank you for filling out your owner registration. [. . . ] Check with local codes for possible disposal instructions. Released electrolyte is corrosive and may cause damage to eyes or skin and may be toxic if swallowed. Exercise care in handling the battery pack in order not to "short" the battery contacts with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns. Charge the battery pack in accordance with instructions supplied with this unit. Observe proper orientation between battery pack and charger contacts. SAVE THESE INSTRUCTIONS 5 CA 10_1 12/12/01 3:46 PM Page 16 STEP 1 SETUP Connect the CA10 Amplifier to your telephone using the illustrations on page ii. Unplug the telephone handset from the jack on your telephone base and insert into the Handset Jack 26 on the underside of the CA10 Base Unit. Using the Short Cord 28 provided, plug one end into the CA10 Telephone Jack 27 and the other end into your telephone's handset jack. Now connect the AC Adapter 23 to the AC Adapter Jack 24 and into a wall outlet. The Power LED 13 will light after connected, but the In-Use Indicator Light 14 will remain off. Make sure you remove the shipping battery insulator pull tab located between the Remote Unit and the Battery Pack. Attach the Remote Unit to the Battery Pack. The Remote and Battery Pack slip together easily and gently snap in place. Connect your headset to the Remote Unit Headset Jack 3 . Press the Headset Cable into the Retainer 6 . If you are using a headset whose cable terminates in a Quick DisconnectTM (QD) module, you will need the QD to 2. 5mm Headset Adapter Cable 11 (P/N 43446-02). Firmly slide the Remote Unit and Battery Pack into the Charging Well 19 until the Charge Indicator 15 lights. A G B C 6 CA 10_1 12/12/01 3:46 PM Page 17 Note: Remote Unit must remain in the Base for 5 seconds to establish a communications link before the system can function. Prior to first use, the Battery must charge for 8 hours before the Remote will operate away from the Base. You may, however, use the Remote while it is in the Charging Well. (Note: May increase charging time. ) The Charge LED will turn off after the Battery is fully charged. You are now ready to make or receive calls. 7 CA 10_1 12/12/01 3:46 PM Page 18 STEP 2 PLACING A CALL With your headset in position, place the handset off-hook. Press the Talk Button on either the Remote 2 or the Base Unit 18 . [. . . ] Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on another circuit. Consult the dealer or an experienced radio/TV technician for help. FCC REQUIREMENTS--PART 68 This equipment complies with Part 68 of the FCC rules. [. . . ]