User manual PLANTRONICS CA12CD DECLARATION OF CONFORMITY

[. . . ] 1. 6 Attach a headset to the remote unit. 1. 7 Place CA12CDs at least 30. 5 centimetres away from CRT-type computer monitors. 2. 1 To attach the battery pack to the remote unit, simply slide the battery pack onto the remote unit and snap it into place. 2. 2 The base unit is equipped with two battery-charging wells. The larger well allows charging of the battery while it is attached to the remote unit. [. . . ] 2. 4 When a battery pack is charged, its charging indicator will stop blinking and glow steadily. 2. 5 The on-off indicator on the remote unit will begin to flash as soon as the unit is ready for use. This may require about 45 seconds while the remote unit determines and selects the most reliable radio channel. 2. 6 A fully charged battery pack will last for up to eight hours. 2. 7 To maximise the life of the battery pack, turn the remote unit off and place it into the charging well when not in use. Prior to being used, battery packs must be charged for at least one hour or until the charging indicator changes from blinking to continuously on. 2. 8 A completely depleted battery requires three hours to fully charge. Note: Always release (disengage) the PTT button before swapping battery packs. Warning: Touching the battery-charging contacts or placing objects other than the battery packs and remote unit in the charging wells may adversely affect the operation of the CA12CD. Charging well for spare battery pack Charging well for remote unit SPARE CHARGE TALK VOLUME REMOTE CHARGE BASE POWER TALK 1. 5, 2. 1, 2. 3, 2. 4 3 3. 4 Operation 3. 5 To get the best audio performance from your CA12CD, please use the guidelines on the separate card, setting model CA12CD audio levels. Properly adjusted audio levels are especially important for avoiding side-tone echo, as well as for being able to hear your callers and be heard clearly by them. 3. 6 The base unit and the remote unit are paired with each other at the factory in a process called subscription. If you replace your remote unit or if your remote unit loses its subscription (shown by a rapidly flashing on-off indicator), you can perform the subscription process as follows: · Hold both of the talk (sending) fine-adjust volume controls on the top of the base unit down. However, the use of wireless radios may be restricted in some situations or environments, such as on board aeroplanes. If you are unsure of restrictions, you are encouraged to ask for authorisation before turning on the wireless radio. NOTE: Modifications not expressly approved by Plantronics, Inc. could void the user's authority to operate the equipment. TECHNICAL ASSISTANCE Visit our web site at www. plantronics. com/support for technical support including frequently asked questions, compatibility and accessibility information. The Plantronics Technical Assistance Center (TAC) is also ready to assist you on 800-544-4660. SuppLIES AND ACCESSORIES AC Adapters Remote North America (shown): 64401-01 European Union: 47249-02 United Kingdom: 64784-01 Australia: 66804-01 North America 90224-01 (UPCS) 90224-02 (DECT) Function Causes relay closure in base unit that "keys up" user's radio Enables or disables locking operation of the PTT Switch Toggles the RF link between the idle-locked and enabled states Adjusts the listen (receiving) sensitivity in 2-dB steps Adjusts the listen (receiving) sensitivity in 6-dB steps Talk (sending) fine-adjust volume Adjusts the talk (sending) control momentary push buttons sensitivity in 2-dB steps on base unit top Talk (sending) coarse-adjust volume control slide switch on base unit bottom Adjusts the talk (sending) output for carbon, electret or dynamic mic applications VISIBLE INDICATORS Name Remote unit: green on-off indicator Aspect 1) Flashing slowly to conserve battery charge. 2) Flashing rapidly to indicate loss of subscription. 1) On continuously when the base unit is connected to power via the AC adapter. 2) Flashing when base unit is in subscription mode. On steadily when PTT button is depressed. [. . . ] 2) Warns of lost subscription when flashing rapidly. 1) Shows that the base unit is powered up. 2) Indicates that subscription is occurring. Shows PTT status. Base unit: green base power indicator Base unit: green talk indicator Base unit: orange charging indicators Console interface cable 68331-01 6 wire, modular-to-PJ7 cable assembly Connectors other than the PJ7 are available upon request Battery Pack 90225-01 Shows battery and charger status. WEEE DISPOSAL INFORMATION Products labelled with the symbol of a crossedout wheelie bin as shown below are electrical and electronic equipment. [. . . ]