User manual PLANTRONICS DISCOVERY 665

[. . . ] Snap battery charger to charging pocket. Ensure that the indentation on the battery charger connector aligns with the shirt clip on the charging pocket. Insert the headset into the charging pocket. A B CAUTION Only replace with a non-rechargeable AAA battery. DISCONNECTING COMPONENTS To separate components, grasp both the battery charger and the charging pocket with the shirt clip facing you. Bend the components back and they will snap apart. [. . . ] Turn off the headset by pressing the call control button for 6-8 seconds until the indicator light glows red or until you hear the beep. The indicator light remains unlit when the power is off. CHARGE LEVEL INDICATION When the headset is turned on, the indicator light will briefly show the headset charge level. 3 red flashes = greater than 2/3 battery charge 2 red flashes = 1/3 to 2/3 battery charge 1 red flash = less than 1/3 battery charge 7 ADJUSTING FIT Right Ear R L N 3. 2. The Plantronics Discovery 655 and Discovery 665 headsets come with three soft gel ear tips and an optional ear loop. The medium-sized ear tip is preinstalled and aligned for wearing on the right ear (R). For left ear wearing, twist the ear tip counter clockwise. Place the headset into your ear and check to see that it fits comfortably. If the headset is either too tight or too loose, remove the medium- sized ear tip from the headset by turning the ear tip to the center or neutral position. In the neutral position, the ear tip can easily be removed by pulling the ear tip directly away from the headset. Next, select the ear tip size that fits most comfortably in your ear. Hold the ear tip with the elongated edge pointing down toward the neutral position and then push the ear tip onto the headset. USING THE OPTIONAL EAR LOOP The ear loop may be attached to the headset to improve stability. Remove the ear tip from the headset by turning the ear tip to the center or neutral position and pulling the ear tip away from the headset. Attach the ear loop between the ear tip and the headset. Replace the ear tip. 8 USING YOUR HEADSET ANSWERING/ ENDING/MAKING CALLS To answer or end a call, briefly press the call control button. To make a call, enter number on your phone, press send, and the call is automatically transferred to the headset; no need to press the call control button. NOTE When answering a call, wait until you hear a ring from the headset itself (not the ring from your phone), before pressing the call control button. ADJUSTING VOLUME To increase listening volume, press the upper end (+) of the volume/mute button. To decrease listening volume, press the lower end (-). CAUTION For your comfort, health, and safety, do not exceed moderate listening levels. AUTO ANSWER If the headset is placed in the carrying pocket when a call is received, the charging pocket will vibrate (Discovery 655) or light up (Discovery 665) when connected to power. Removing the headset from the pocket will automatically answer the call. Returning the headset to the charging pocket will end the call. MUTE A CALL To turn the mute on while on a call, press both sides of the volume/mute button simultaneously until you hear a beep. [. . . ] · This warranty extends to you only if you are the end user with the original purchase receipt. To comply with FCC RF exposure requirements, only use supplied antenna. Any unauthorized modification to the antenna or device could void the user's authority to operate this device. 15 Plantronics, Inc. 345 Encinal Street Santa Cruz, CA 95060 USA Tel: (800) 544-4660 www. plantronics. com © 2006 Plantronics, Inc. [. . . ]