User manual PLANTRONICS HL 10

[. . . ] The top edge of the lifter should touch the earpiece of the handset when the handset is placed in the cradle (Fig. Verify that the microphone on the HL10 is located above the telephone ringer speaker. If not, you will need to attach the Ringer Microphone (9). [. . . ] Clean the cradle and speaker areas of the phone and replace the handset. If the handset still does not lift and lower smoothly, your telephone may require the Extender Arm accessory. The Stabilizers (7) can be shifted to the left or right to improve the stability of the handset on the HL10. Read "Adjusting the HL10 for Your Telephone" to determine the correct HL10 height. MOUNTING THE HL10 IN A PERMANENT POSITION Once you have determined the best position for the Handset Height Switch (5), you can mount the HL10 on your telephone base. NOTE: If the side of the phone is curved, the protective cover on the MAKING AND RECEIVING CALLS While wearing your headset, press the talk button to activate the HL10. When you hear a dial tone, use the telephone key pad to dial the number (Fig. To end the call, press the talk button again. the HL10 will return the handset to the cradle and disconnect the call. If your headset does not beep when the phone rings, you may need to adjust the ringer on your phone. For best results, choose a traditional ring pattern on your phone. If necessary, try different settings of ring pattern and volume until the headset beeps when the phone rings. If your headset still does not ring, attach the Ringer Microphone Plug (10) to your HL10 and place the Ringer Microphone (9) over the ringer speaker of your phone. USING THE RINGER MICROPHONE (IF REqUIRED) If the HL10 microphone is not located above the ringer speaker on your phone, you must install the optional Ringer Microphone (Fig. You should hear a beep in the headset when you receive a call. Remove the protective cover from the mounting tape and attach the Ringer Microphone (9) to the telephone ringer speaker. [. . . ] When using telephone equipment and accessories, basic safety precautions should be taken to reduce risk of fire, electric shock, and injury to persons. Keep fingers and other objects clear of the lifting pad. To reduce risk of electric shock, do not disassemble this product. [. . . ]