User manual PLANTRONICS T10

[. . . ] Slots and openings in the base unit and the bottom or back are provided for ventilation, to protect it from overheating; these openings must not be blocked or covered. The openings should never be blocked by placing the product in the bed, sofa, rug or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation unless proper ventilation is provided. [. . . ] HEADBAND USE Snap the Adjustable Headband into the back of the Headset Assembly . Press the Ear Cushion Assembly onto the Headset Assembly , aligning the notch in the ring with the Voice Boom. Place the Headset on either ear and adjust the Headset to a comfortable position by moving the Adjustable Headband. Position the Voice Boom EARLOOP USE Press the Pivot Ball Ring onto the Headset Assembly. C A near the corner of your mouth. B Insert one of the Earloops into the Pivot Ball. You may need to try each size to find the most comfortable fit. Slip the Earloop over your ear and position the Voice Boom near the corner of your mouth. CLOTHING CLIP The Clothing Clip keeps the Headset free from the weight of the cord. Attach the clip to your clothing at about chest level. Allow enough slack in the cord (approximately 6 inches) to permit your head to move without pulling on the Headset or the Clothing Clip. You are now ready to make or receive calls. D 6 STEP 3 PLACING A CALL With the Headset in position, place a call by pressing the On/Off Button (In-use Indicator and On Line Indicator Lights are on). Dial the desired number using the Twelve Button Dial Pad. When your party answers, speak normally. If your party cannot hear you, see Troubleshooting (page 12). Adjust the Listen Volume Control other party. as needed to hear the E RECEIVING A CALL With the Headset in position, when the ringer notifies you of an incoming call, press the On/Off Button to answer the call (In-use Indicator and On Line Indicator Lights are on). 7 CONVENIENCE FEATURES REDIAL FEATURE The base unit will store the last number dialed. The last number can be automatically redialed by pressing the Redial Button. FLASH FEATURE If your telephone service includes call waiting, the Flash Button allows you to toggle between two calls. When your phone alerts you to a second call, press the Flash Button to place the current call on hold and to immediately connect you to the second call. Press the Flash Button again to return to the first caller. This feature can also be used with most office telephone systems to transfer a call to another extension. Press Flash to hear a dial tone, enter the extension number, after the extension rings, press Flash again or hang up to transfer the call. MUTE FEATURE When you activate the Mute Button , the calling party cannot hear your voice but you will be able to hear the calling party. [. . . ] In most, but not all areas, the sum of the RENs of all devices connected to one line should not exceed five (5. 0). To be certain of the number of devices you may connect to your line, as determined by the REN, you should contact your local telephone company to determine the maximum REN for your calling area. Connection to the telephone network should be made by using standard modular telephone jacks, type RJ11. The plug and/or jacks used must comply with FCC 11 FCC 1 STEPREGISTRATION INFORMATION Part 68 rules. [. . . ]