User manual PLANTRONICS VOYAGER 510

[. . . ] Then dial a co-worker and while speaking, turn the configuration dial through the 4 positions. Select the position that provides the best sound quality for both you and your co-worker. During this call you should also adjust the Listen and Speak Volume as described next. Once set, the configuration dial will not require any further adjustment. 8 A B PLACING A CALL Placing a call on your corded telephone: Lift the handset and then press either the Call Control button on the headset (A) or base unit (B). [. . . ] The handset lifter then lowers the handset to end the call. RECEIVING A CALL USING THE LIFTER When a new call is received the telephone rings as normal, but in addition, a ring alert will be heard in your headset. Note: This additional call alert is only active when the Handset Lifter is connected. To answer the call press the Call Control Button on either the headset or the base unit. The lifter will then raise the telephone handset off the hook and you will then be able to talk to the caller. When you have finished your call press the Call Control Button on either your headset or base unit. The handset lifter then lowers the handset to end the call. 12 SWITCHING FROM HEADSET TO HANDSET WHEN USING THE LIFTER If during a call you are using your headset and want to switch to the telephone handset, remove the handset from the Lifter, then press the Call Control Button on either your headset or the base unit. The Lifter will lower and you will then be able to continue the call using the handset. SWITCHING FROM HANDSET TO HEADSET WHEN USING THE LIFTER If during a call you are using the telephone handset and want to switch to your headset, press the Call Control Button on either the headset or the base unit. The Lifter will raise and you will be able to continue the call using your headset. Replace the telephone handset on the Lifter. When the call is finished press the Call Control Button on either your headset or base unit. The Lifter will lower the handset and end the call. INTELLISTANDTM ENABLE/DISABLE When the Voyager 510 Bluetooth® Headset System is used in conjunction with a Plantronics Handset Lifter, you can enable the IntelliStandTM feature. The IntelliStandTM senses when the headset has been removed or replaced in the Voyager 510 System Base unit, automatically activating the lifter to answer or end a call. The IntelliStandTM feature is disabled when the switch is in position I (as shown) or enabled when the switch is in position II. Note: Docking the headset always ends the call regardless if IntelliStandTM is enabled or disabled. 13 AUDIBLE WARNINGS OUT OF RANGE WARNING As you walk away from the base unit you will eventually reach the system operating range limit. The system will issue audible warnings at the operating limit. If not in a call: One low tone when edge of range reached. If in a call: One low tone when edge of range reached. One high tone followed by a triple tone when back in range On hearing the edge of range alert you should walk closer to the base unit to ensure call quality is maintained. If you stray out of range any active call will be suspended. The call will be re-established on walking back in range If you remain out of range for more than 10 minutes the system will drop the call permanently. [. . . ] Incorrect Configuration Dial setting for your telephone Try other Configuration Dial settings on the base unit. 18 PROBLEM Callers cannot hear me. Possible Cause IntelliStandTM function is enabled. Solution To disable the IntelliStand function move the IntelliStandTM Switch to position I (Off). PROBLEM Headset loses response to button presses Headset needs a reset. A hardware reset of the headset can be accomplished by a simultaneous long press of the POWER/MUTE and SPEAK VOLUME DOWN keys. 20 Plantronics Ltd Wootton Bassett, UK Tel: 0800 410014 +44 (0)1793 842200 Plantronics B. V. [. . . ]