User manual POLAROID DMC 1E

[. . . ] This action may also void your warranty. Contact Polaroid Technical Support or your dealer if the camera is malfunctioning. (To contact Polaroid from within the U. S. A. , call 1-800-432-5355. Outside the U. S. A. , see Obtaining Technical Assistance in the online user's guide or visit www. polaroid. com on the World Wide Web. ) 3 4 5 6 7 English 3 English 4 2 Install the Software 1 Turn the computer on. [. . . ] If your computer is a PC-compatible with a SCSI adapter, but the adapter is connected to a hard drive or CDROM drive, installing a second adapter is recommended. Set the camera SCSI address: Each device connected to a SCSI host adapter must have a unique address from 0-6. To assure a unique address for the camera, determine the addresses of any other SCSI devices: Power Mac or PowerPC · Run Apple System Profiler, usually on the Apple menu. If it is not, it may be available from www. apple. com/ swupdates. · Click Devices and Volumes to view the SCSI device addresses. Windows 95, 98 or NT · Look at the SCSI address switch on each SCSI device connected to your system. If necessary, see the instructions provided with the devices. Turn the camera power switch to off (0) and set the SCSI address switch to a value not used by any other device. Power switch?(off=0) SCSI address switch Do not use 7, 8 or 9?(not valid addresses) Note: The address is preset to 4. Do not change it unless another device is using 4. Other addresses typically available are 2, 5 and 6. Connect the SCSI cables: Place the DMC camera at the end of the SCSI chain as shown or between the computer and other SCSI devices. Use the shortest possible cables. DMC Ie camera termination on (1) Set termination: The last device in a SCSI chain must be terminated (or have termination on), while all other devices must be unterminated (or have termination off). Computer Termination switch Other SCSI device (not terminated) Note: Turn the computer, camera and all other SCSI devices off before connecting or disconnecting any cables. Do not connect the camera to the parallel connector on your computer. Doing so could damage the camera or computer. If the camera is the only device connected to your SCSI host adapter or the last device in a SCSI chain, set the camera termination to on (1). Termination instructions for your other SCSI devices are provided with the devices. Note: Do not use an external, passive terminator to terminate the camera. If another device is at the end of the SCSI chain, that device must be terminated with an active terminator for proper camera operation. English 7 English 8 5 Connect the Camera to AC Power and Turn On 1 Connect the camera to AC power and turn the power switch on. 2 Verify that the green and yellow LEDs are on, indicating AC and 1 Power switch (on=1) termination power are on. 4 Wait for the system to install the camera driver and display the normal desktop. To AC power Green LED 2 Yellow LED 6 Take a Test Picture 1 Start the DMC Ie program: Power Mac or PowerPC · Double-click Polaroid DMC Ie. Windows 95, 98 or NT · Select Programs from the Start menu. · Point to Polaroid Digital Microscope Camera and select Polaroid DMC Ie. [. . . ] If your PC uses the Windows NT operating system, log in as an administrator before installation. ) Note: A SCSI host adapter may be provided as an option with the camera. If necessary, obtain an adapter from your computer dealer. (Adapters are not available for iMac computers. ) © Copyright Polaroid Corporation, 1999. "Polaroid" is a registered trademark of Polaroid Corporation, Cambridge, MA, U. S. A. [. . . ]