User manual POLAROID FLM-3701

[. . . ] Programming the Polaroid Universal Remote Control Following are two sets of instructions for programming your Polaroid Universal Remote Control to work with other devices in addition to your Polaroid TV. (If you only wish to use the remote control with your Polaroid TV, no additional programming is necessary. ) Begin with the Direct Programming Setup, and if unsuccessful, go on to the Auto Code Search Setup. Direct Programming Setup This method requires use of one of the device codes found in the Device Code Table (see last pages of your Operating Manual). [. . . ] Repeat steps 2-4, this time choosing the next code in the list. 5 Press the Power button (top right-side button) on the remote and your device power should turn on. If the power does not turn on, repeat the entire procedure beginning with step 1. If you are unable to program the remote properly after two or more attempts using the Direct Programming Setup, go on to the Auto Code Search Setup. 39 Auto Code Search Setup This method does not require use of the Device Code Table. 1 Turn the device power off and point the Polaroid Universal Remote Control at the device you wish to control. 2 Momentarily press a device button on the Polaroid Remote Control (TV, DVD, CBL, or AUX). When you release the device button the red LED at the top of the remote will blink once. Note: For devices other than a TV, DVD, or Cable Box, use the AUX key. 3 Press and hold the SET button (top-left button) until you see the LED blink once, followed by two short blinks. Release the SET button after you see the two short LED blinks. [. . . ] 8 When the device turns on, press and hold the SET button until you see the LED blink twice. The code is now saved, and the remote should operate properly. 40 [. . . ]