User manual POLAROID HOLGA FILM HOLDER

[. . . ] Carry disposable bags when taking pictures. The use of Polaroid Peel-Apart films generates waste such as pull tabs and negatives. Always carry a disposable bag when taking photographs outside. Folding the Negatives Fold the negatives as shown in the pictures to the right for convenient disposal. HOLGA by Polaroid Instructions for the HOLGA Polaroid Holder 1. Before taking a photograph using the Polaroid Film Dispose of negatives and film cassettes as inflammable waste. Cleaning the Rollers Contamination of the rollers of the Polaroid holder results in uneven development. [. . . ] The number of pull tabs equals the number of pictures. Ensure that the lightproof paper is protruding out of the holder before closing the cover. Return the latch to its original position, and pull out the lightproof paper. The light proof paper should be pulled out at a constant speed in a straight and parallel direction. 3. Taking a photograph using the Polaroid Film Always pull out the lightproof paper before taking the photograph. Furthermore, always insert the screen when finished with the camera or when removing the Polaroid holder from the camera. Insert and store the extracted screen at the back of the Polaroid holder for safekeeping. Polaroid Film Guide Polaroid films, which can be used with HOLGA, consist of the Peel-Apart Film Type 80 series. Enjoy adding different characteristics to your pictures with the 5 different variations of Type 80 (84, 85, 87, 88, and 89). Polapan 84 (ISO 100 Black and White) A black and white film with a beautiful natural gradation using a wide grey scale. Characteristic: Easy to use which is not subject-selective. · Development Time: 30 seconds (24°C) 4. Taking a photograph using the Polaroid Film Polapan 85 P/N (ISO 80 Black and White Positive/Negative) A black and white film which creates high-definition negatives at the same time as the prints. The ultra-fine particle negatives which hold more than 10 times the data of a print can be used for enlarged prints. · Development Time: 30 seconds (21°C) · Coating required A) After taking the photograph, pull the pull tab of the film (the white, small tab with numbers printed on it). Make sure that the tab is parallel when pulling. Check that the remaining pull tabs are lined up inside the Polaroid holder. B) Pull the leader tab (the tab with the arrow printed on it) in a straight and parallel direction, and extract the film (pull out at a constant speed without pausing). C) Place the film in a level position, and measure the development time. The development time differs according to the type of film and the temperature, and should be measured in accordance with the film manual. Polapan 87 (ISO 3000 Black and White) A black and white film capable of taking clear pictures in dark locations due to ultra-high sensitivity. [. . . ] · Development Time: 60 seconds (21°C) Important Polaroid peel-apart films use a single paste. Please refer to the film manual concerning this substance. PolaColor 89 (ISO 100 Color) A color film which uses a hybrid emulsion, producing a color photograph with a natural tone due to sharp picture quality and clear color reproduction true to the subject. · Development Time: 90 seconds (21-35°C) [. . . ]