User manual POLAROID MACRO 5 SLR

[. . . ] Film counter Counts down, indicating the number of pictures remaining in the pack. The knob clicks into position at each magnification; the camera will not function if the knob is between lens settings. In addition to the magnification, the selector shows the camera-to-subject distance and icons that represent the approximate area of a subject included in the picture. dirt or bits of dried developer on the rollers can cause a pattern of repeated spots or bars on pictures. [. . . ] Press the light arrow to lighten pictures Ranging lights on the subject (10). Move the camera nearer or farther from the subject, until the two lights merge (11). Press the dark arrow to darken pictures Press the opposite arrow until green light aligns directly over the vertical line (return to nominal position). The camera has a memory and saves your custom Lighten/Darken settings. 4 The viewfinder shows the area included in the Picture, with the ranging lights in the center of the picture. If you have difficulty seeing the ranging lights, check that the camera is at the correct distance from the subject. The two built-in electronic flash units are designed to provide even illumination at all reproduction scales. Take the picture Outdoor use Look through the viewfinder, and reframe the subject as needed. Press the shutter button all the way to take the picture (12). The picture automatically ejects from the front of the camera when you release the shutter button. Lay the picture down flat or hold it by its wide border while it develops. Never leave film or a loaded camera in a hot area (such as the luggage compartment of a car). Difficulty focusing The ranging lights may be difficult to see when using the camera in very bright light, or when photographing very dark subjects. If you have difficulty seeing the ranging lights: Magnification, and is at the correct distance from the subject. Move the ranging lights to a lighter area on Look over the top of the camera, rather than through the viewfinder. Camera does not function The flash and/or LED ranging lights will not function if the film pack battery is weak or dead. no image in viewfinder The magnification selector knob is between settings. Pictures too light The camera may be too close to the subject for the selected magnification. Polaroid Corporation certifies that this product conforms to the following standards: Safety: Low Voltage Directive 73/23/EEC EMC: EN55022, Class B; EN50082-1; IEC 801-2, 801-3 If you need assistance or additional information please contact a Polaroid dealer, or office nearest you. , call us toll free at 1-800-343-5000, Mon. 2 This device must accept any interference Received, including interference that may cause undesired operation. Only) Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ] During this period, any such defects will be remedied by Polaroid Corporation without charge, except for transportation costs. The warranty excludes damage resulting from normal wear, mishandling or accident, and a charge will be made for such repairs. : This warranty does not affect your statutory rights. The camera should be packed in its original shipping carton or other sturdy container, and shipped, prepaid and insured, to the nearest Polaroid Office. [. . . ]