User manual POLAROID POLAVIEW SUPERPORTABLE 10

[. . . ] Polaview SuperPortable 10 FCC Statement Warning: This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with limits for a Class "A" computing device pursuant to Subpart B of Part 15 of the FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference in which case the user, at his own expense, will be required to take whatever measures may be necessary to correct the interference. Warning: Changes or modifications to this unit not expressly approved by Polaroid could void the user's authority to operate the equipment. Canadian Notice This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe A prescrites dans le Règlement sur le brouillage radioélectrique edicté par le ministère des Communications du Canada. European Notice Warning: This is a Class A product. [. . . ] To use the remote control, point it at the front of the projector and press a key, or bounce the infrared (IR) signal off the projection screen. Note: When the operating distance between the projector and remote control becomes too short for your purposes, install a fresh battery as described in the Changing the remote-control battery section in Chapter 4, Maintenance. The RC-8 remote control a b c d e f g h i j a SOURCE b LED indicator c Arrow keys (alignment) d BRIGHT (BRIGHTNESS) e MENU f F2 g RESET h LAMP (REPLACE LAMP) i CONTRAST j VOLUME 24 Using the projector Menu-mode on-screen controls The Menu-mode on-screen controls let you adjust the projected image and enhance the appearance of your presentation. The function of each on-screen control is described below. INVERSE To use the INVERSE function, press and release MENU, then press either the v or w key to scroll through the menu until you display INVERSE. Press either the or key to switch between positive and negative images. A graphic appears on the screen to indicate the current INVERSE setting. To use the WIDTH function, press and release MENU, then press either the v or w key to scroll through the menu until you display WIDTH. Press the key to increase the width of the image. Press the key to reduce the width of the image. A graphic appears on the screen to indicate the current relative value of the WIDTH setting. WIDTH may affect the FOCUS control; refer to the Troubleshooting guide in Chapter 5 for more information. To use the FOCUS function, press and release MENU, then press either the v or w key to scroll through the menu until you display FOCUS. Press either the or key to select from 8 possible image-phase-adjustment settings. A graphic appears on screen to indicate the current FOCUS setting. The WIDTH control may affect FOCUS; refer to the Troubleshooting guide in Chapter 5 for more information. To use the MIRROR function, press and release MENU, then press either the v or w key to scroll through the menu until you display MIRROR. Press either the or key to switch from the standard to the mirror (reverse) image. A graphic appears on screen to indicate the current MIRROR setting. WIDTH FOCUS MIRROR Using the projector 25 PALETTE To use the PALETTE function, press and release MENU, then press either the v or w key to scroll through the menu until you display PALETTE. Press either the or key to switch from one of two color modes: 8-color or 16, 194, 277color. A graphic appears on screen to indicate the current PALETTE setting. To use the TINT function, press and release MENU, then press either the v or w key to scroll through the menu until you display TINT. Press the key to increase the red in the color image. Press the key to increase the green in the color image. A graphic appears on screen to indicate the current relative value of the TINT setting. [. . . ] Ponce de León 701 Miramar, Santurce 00907 Tel. : (809) 725-6240 Fax: (809) 725-5462 Schweiz/Suisse/Svizzera Polaroid AG Hardturmstrasse 133 8037 Zürich Tel. : (01) 277. 72. 72 Suomi Polaroid Oy Sinikalliontie 10 02630 Espoo Puh: 90-502 35 33 Fax: 90-502 35 50 Sverige Polaroid AB Ekholmsvägen 34 Box 204 127 24 Skärholmen Tel. : 08-710 08 50 Fax: 08-740 73 68 U. K. & Polaroid Export Operations Wheathampstead House Codicote Road Wheathampstead Hertfordshire AL4 8SF U. K. Tel: (44) 1582 632000 Freefone: 0800 010119 U. S. A. Polaroid Corporation Technical Assistance Tel. : Toll free 1-800-432-5355 Call for the nearest Polaroid location 46 Troubleshooting One Year Warranty Polaroid Corporation warrants your Polaview Projector equipment against defects in manufacture for a period of one year from the date of purchase. [. . . ]