User manual POLAROID PROPACK CAMERA

[. . . ] ProPack Camera User Guide Underwriters' Laboratories, Inc. requires that the following information be provided. IMPORTANT SAFEGUARDS AS WITH ANY BATTERY-OPERATED EQUIPMENT, OBSERVE THESE BASIC SAFETY PRECAUTIONS. 2. CLOSELY SUPERVISE UNIT WHEN IT IS BEING USED BY OR NEAR CHILDREN. 4. DO NOT USE UNIT IF IT HAS BEEN DROPPED OR DAMAGED -- UNTIL IT HAS BEEN EXAMINED AT AN AUTHORIZED POLAROID SERVICE CENTER. [. . . ] The flash range for Hi-Power cubes is 4-12 ft. (1. 2-3. 7m) and for regular cubes is 4-8 ft. (1. 2-2. 4m); be sure your subject is within those ranges. Set the film selector to 3000 for 3000 speed film and to 80 for 80 speed film. To take pictures with the ProFlash (ProPack System only) For best results, place your subject near a lightcolored background, if possible. When photographing more than one subject, place each subject about the same distance from the camera so they all will be lit evenly by the flash. The green LED will light when the flash is fully charged. Be sure the film selector on the camera is correctly set for your picture-taking situation. Note: For distant subjects (50-75 ft. /15. 2-22. 9m) at night, you must use 3000 speed film and set the film selector to 80. Color film cannot be used for flash pictures beyond approximately 12 ft. (3. 7m). Film Color ISO 80/20o* B&W ISO 3000/36o B&W ISO 3000/36o Film selector 80 3000ER 80 Flash range 3 1/2-12 ft. Make sure the ready light (20C) is lit, indicating the flash is fully charged. ProPack System: Hold the camera by the handgrip on the ProFlash while pulling tabs, as shown in (11). ProPack camera: Hold the camera by the ring handle while pulling tabs so the camera hangs freely, as shown in (12). Pull the white tab Grip the center of the white tab. If no yellow tab appears when you pull a white tab, see below. Pull the yellow tab Grip the center of the yellow tab. Pull straight, at a moderate speed, until the film is out of the camera (23). Start the timer The correct development time should already be set (see "Set the digital timer"). Press the START button once (24); the timer will count down from the preset time to zero. At the end of the development time, a series of short tones will sound. Peel the print immediately, as described below. [. . . ] Without this information, the warranty period is two years from the manufacturing date on the equipment. If, within the warranty period, the equipment is mailed to us for service from inside the U. S. A. , it will be returned with a postal refund. This warranty does not cover damage caused by accident, misuse, or tampering with the equipment, and a charge will be made for such repairs. For warranty service the equipment must be returned to and repaired by a Polaroid Service Center or Authorized Service Center. [. . . ]