User manual POLAROID PROPALETTE QUICK START GUIDE

[. . . ] After setting film recorder attributes or causing the film recorder to perform an action, exits the menu system. Press the Escape key once to enter the Change Setup?Once you have set attributes or the film recorder has performed an action, press the Escape twice to exit the menu system. 4. Pull the end of the film gently to the right until the end reaches 1/2" past the white triangle at the lower right. [. . . ] A device-setup item (for example, SCSI Terminated?) sets a film recorder attribute. A device-activation item (for example, Rewind Film) causes the film recorder to perform an action. 2. Steady the camera insert with your left hand, and pull the top latch on the film door up and the bottom latch down with your right hand. If the black arrow is pointing to the type of film (120 or 220 length) you are loading, proceed to step 5. LR BC NI-Cd Loading 4x5 Film 1. Verify that the 4x5 camera back is attached, and turn the film recorder on. 120 P 220 OFF ON Loading 35 mm Film 1. Verify that the 35 mm camera back is attached, and turn the film recorder on. 2. In a darkroom, load the 4x5 film holder with film. Orient the film with the notch positioned as shown. 120 P 220 If the black arrow is not pointing to the correct film type: aHold the camera insert in your left hand. Do not set it down on a flat surface. LR BC NI-Cd OFF ON Some 4x5 films 2. Slide the film door button on the camera back down and open the door. 3. Insert the film cassette at an angle into the chamber. Push the cassette in fully, so that the film lies flat against the track. are available in Readyload packages. When used with the Polaroid 545 or the Kodak Readyload Packet film holder, you can load the film holder outside of a darkroom. 3. Pull open the outer section of the camera back enough, but no more than 2", to slide the film holder in. Do not pull the Make sure you're fingers are not touching the pressure plate on the back of the camera insert. bPush in the pressure plate dial and turn it clockwise until the arrow points to the film you are loading (as printed on the film package). 4. Turn the camera insert around, verify that the film type appears in the display window, and check that the plate is locked into position. If the plate is not locked into position, turn the pressure plate dial slightly until it snaps into position. Do not touch the shutter when loading the film. outer section too far. This can cause the camera back to pop out of the springs and require Service Center repair. Insert the 4x5 film holder into the camera back from the right. To avoid light leak, make sure that the left side of the film holder lies snugly against the left side of the outer section of the camera back. P 5. Turn the camera insert so that the OFF/ON switch is on the bottom. If the empty spool is on the right (take-up) side, proceed to step 6. [. . . ] "Polaroid" and "Polaroid ProPalette" are trademarks of Polaroid Corporation, Cambridge, MA, U. S. A. All other product names may be trademarks of their respective owners. P OFF ON LR BC NI-Cd If the film does not wind evenly, remove the spool, take out the film, and reinsert the end of the film into the take-up spool slot and restart rewinding. Check that the top and bottom latches are fully open. P Seat the camera insert tightly onto the camera back. [. . . ]