User manual POLAROID TTM-2410

[. . . ] Unplug the apparatus from the AC outlet when it will not be used for a long period of time. And when there is a lightning, unplug the unit from the AC outlet immediately. Never touch the antenna wire during lightning. 3. The apparatus is not suitable for children under 3-year to operate. i Important Safety precautions 4. [. . . ] Digit buttons on the remote control are used for direct channel selection. Press 0-9 to select a channel (interval time of two or three pressing should be less than 1. 5 seconds), for example, to select channel 10, press 1 and 0, the channel will change after 1. 5 seconds. If you input 0 firstly, when input the second number, the channel will change to this channel number without waiting, for example, to select channel 8, press 0 and 8, the channel will change immidiately. 8 Remote control Remote control DISPLAY PRE. CH Displays channel information. Returns you to the previous channel. If the user is in the menu system, Go Back will take the user to the previous menu screen. BROWSE "Browse"feature. Pressing the button twice will begin channel scan, again will stop at current channel. PIC Steps through picture presets MEMORY, STANDARD, DYNAMIC and MILD. CLEAR Remove any menu or display form the screen and returns you to TV reviewing. For menu with digit inputs , pressing CLEAR button will clear the last number entered. TV/AV Toggles the set between available AV inputs and RF input. VOL (left and right)buttons Decrease or increase the TV's volume, or move through the on-screen menu system. CH. (up and down)buttons Scan up or down through the current channel list. Press once to change the channel up or down;press and hold to continue changing channels, or move through the onscreen menu system. SOUND Four preset audio settings for you to select (MEMORY/ STANDARD/NEWS/MUSIC). STEREO Four available audio modes (AUTO/MONO/STEREO/ SAP) CCD Turns on or turns off the closed caption. Loading batteries: Remove the lid of the battery compartment, insert 2 size AAA batteries with the polarities as indicated inside the compartment then replace the lid. Note: 1. One loading of batteries will last 1 year under normal use. If you do not intend to use the remote control for a long period of time, remove the batteries. 9 Basic operation Overview Connect to the mains Insert the mains wire plug of the unit into AC 120V mains outlet. Power on/off When you press the POWER switch button to standby or turn on TV. Note: The power indicator will turn into red when TV is under standby state. The power indicator will die when TV is under turn on state. Non-signal power-off in 5 minutes In case the unit under blue screen or non-signal screen saver state, TV will be standby state automatically 5 minutes later, to turn it on, please press POWER button on TV. Change channels You can change channels by using the CH / button on the remote control). Volume UP/DOWN You can adjust the sound by using VOL / button on the remote control). / button in front of the TV(or the CH button in front of the TV (or the VOL / Sleep function 1. Press down SLEEP button on the remote control to display the preset time 120 minutes, 90 minutes, 60 minutes, 30 , minutes, the unit will be automatically turned off when the set time has elapsed. To cancel the time-off function, press the SLEEP button consecutively until display changes to SLEEP OFF state. [. . . ] Adjust left/right to emphasize left/right speaker balances. Adjust range: (-31~+31). BALANCE SURROUND Adjust different kinds of the surround sound effect. STEREO Adjust different kinds of the stereo sound effect. Provide three states: (PASS, PSEU, MONO ). Using the PRESET menu Using the PRESET menu CHANNEL Use VOL / button in front of TV (or on the remote control) to select channels, or enter the channel number directly using the number buttons. [. . . ]