User manual POLAROID XGA 360

[. . . ] Liquid Crystal Projector Model 360 USER'S GUIDE Thank you for purchasing the Polaroid liquid crystal projector. Please read this user's manual thoroughly to ensure correct usage through understanding. After reading, store this instruction manual in a safe place for future reference. Outline This liquid crystal projector is used to project various computer signals as well as N T S C / PAL/SECAM video signals onto a screen. Little space is required for installation and large images can easily be realized. Contents Page Features (1) Outstanding brightness The UHB lamp and high-efficiency optical system assure a high level of brightness. (2) Partial magnification function Interesting parts of images can be magnified for closer viewing. (3) Distortion correction function Distortion-free images are quickly available. (4) Power zoom and power focus. [. . . ] after that, the indicator will light orange. · After the power is turned off, the lamp will be cooled for approximately 1 min. and the power cannot be turned off even by pressing the STANDBY/ON button. · The standby status will not be entered if the time which the STANDBY/ON button is pressed is too short. 2 3 Turn off the main power switch of the projector [ Attach the lens cap. : OFF]. The fan will continue running for approximately 1 min. Do not turn off the main power switch while the lamp is on because this will shorten the service life of the lamp. Plug & Play This projector is VESA DDC 1/2B compatible. Plug & play is possible by connecting to a computer that is VESA DDC (Display Data Channel) compatible. (Plug & play is a system configured with peripheral equipment including a computer and display, and an operating system. · Use the RGB cable included with this projector when using plug & play. With other cables, pins (12) - (15) are sometimes not connected (effective only for RGB1). · This device is recognized as a plug-and-play monitor. Use the standard Windows95/98 display drivers. · This function may not operate, depending on the personal computer used. · When the DDC function does not operate on a personal computer running Windows95/98, select the display type from Screen Priority. It is recommended that Super VGA 1024 x 768 (60-75Hz) be selected as the display type. The DDC function will not operate when connected to a Macintosh. 14 Basic operations (continued) Freeze function This function is used to freeze the image being displayed. (refer to page 10) 1 1 Press the FREEZE button. · The image being displayed will freeze. · The [ ] mark appears in the lower right corner of the screen when the Freeze function is on. Cancelling the FREEZE function 1 Press the FREEZE button. · The FREEZE function will be cancelled. · The [ ] mark will be displayed for approximately 3 sec. when the FREEZE function is cancelled. · When there is no input signal, the Freeze function is not effective when the input signal is outside the sync range. · Pressing the FREEZE button alternately turns the freeze function on and off. · The FREEZE function will be cancelled when the input select button is pressed or the display mode of the PC being used for display is changed. · When a still image signal is input when the FREEZE function is on, make sure not to forget to cancel the FREEZE function. [. . . ] In such cases, turn off the MAIN POWER switch, allow the set to cool (for approx. 20 min. ) and then turn the power on again. When you think something wrong Before requesting repair, check in accordance with the following chart. If the situation cannot be corrected, then contact your dealer. Symptom The power is not turned on. Possible cause ·The main power switch is not turned on. [. . . ]