User manual POLK AUDIO 5250

[. . . ] Attach your receipt here and file for future reference. I am extremely excited about these Polk Audio/MOMO high performance speakers; this is the first time that the exclusive MOMO Design house of Italy has co-branded a product. We've partnered with them to produce the best sounding, best looking car speakers ever. They are going to make your car look and sound great. [. . . ] Using the hardware retained from the factory speaker or the screw clips supplied with the Polk/MOMO speaker, secure your new speaker to the car panel. Installing the Mid/Woofers in Non-Factory Locations If you have decided to install your Polk/MOMO Series mid/woofers in locations other than those provided by the automobile manufacturer, make certain that the location you choose is clear of all obstructions, both in front of and behind the panel, before you proceed. Pay particular attention to window mechanisms and any body panels critical to the structural integrity of the vehicle. The mounting depths and cutout diameters of your Polk/MOMO Series mid/ woofers are listed with all the other important specifications at the end of this manual. Use the speaker grille as a template for marking the locations of the four screw holes. Cut the supplied driver wire (the heavier gauge of the two sets of wire) in half. Remove the yellow crossover cover by squeezing the cover at the tabs. attach speaker wires to the crossover "woofer" terminals. Attach the wire with the white stripe to the positive (+) terminal screw, and the un-striped wire to the negative (-) terminal screw. Route the driver wire from the crossover location through grommets to the mid/woofer location. Strip 1/8" ­ 1/4" (4-6 mm) of plastic insulation from the cut ends of the driver wire. Unscrew the binding post thumbnuts on the mid/woofers to fully expose the hole in the terminal shaft and slip the other end of the wire into the holes in the input terminals. Tighten the thumb nuts finger-tight (do not over-tighten the nuts as you may strip the threads). Be sure to attach the wire with the white stripe to the positive (red) terminal, and the un-striped wire to the negative (black) terminal. Place the grille over the driver and line up the screw holes with the screw clips on the car panel. Secure the speaker/grille assembly to the car panel with the supplied Allen head screws. Polk/MOMO System Tweeters One important advantage of component systems is their ability, when properly installed, to improve the soundstage created by the music in your car. the soundstage is the musical "picture" made up of the instruments and vocalists. The difference in the soundstage will be dramatic depending on where you mount your tweeters. We recommend a simple experiment that will help you decide the best spot for your tweeters in your car. Complete the installation of your entire system except for the MM tweeters. Connect the wires provided with your tweeters to the tweeter terminals on your Polk/MOMO crossovers. [. . . ] Please do not hesitate to call us if you have questions about your speaker system. Recommended Amplification/ Amplification recommandée Impedance(DCR)/Impédance (DCR) Frequency Response (+/-3dB)/ Réponse en fréquences (+/-3dB) Sensitivity (1w/1m)/ Sensibilité (1w/1m) Cutout Dimensions/ Dimensions de l'embrasure Driver/Transducteur Tweeter Mounting Depth top mount with grille/ Profondeur de montage Montage en surface avec grille Mounting Depth bottom mount/ Profondeur de montage dessous 5" (127mm) 2 3/16" (55. Product Disposal - Certain international, national and/or local laws and/or regulations may apply regarding the disposal of this product. For further detailed information, please contact the retailer where you purchased this product or the Polk Audio Importer/Distributor in your country. [. . . ]