User manual POLK AUDIO AMR130

[. . . ] OWNER'S MANUAL AMR130 5. 1 COMPUTER SPEAKER SYSTEM " " NOTE TO CATV SYSTEM INSTALLER: This reminder is provided to call the CATV (Cable-TV) system installer's attention to Article 820-40 of the NEC, that provides guidelines for proper grounding and, in particular, specified that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Notify your Polk Audio dealer if you notice any difference, damage, or any missing items. They will do the best job of protecting your speakers if they need to be transported. SETUP 1 5. 1 SOUNDCARDS INCLUDING SOUNDBLASTER LIVE, TURTLE BEACH & PHILLIPS PSC706 SOUNDCARDS (Figures 1a & 1b) For 5. 1 mode. Consult your soundcard's user manual or "Help" function for information about configuring the soundcard software. SETUP 2 OLDER, NON-5. 1 SOUNDCARDS How To Get Bass With No Subwoofer Input: When using an older, non-5. 1 soundcard, you will not be using the AMR130's "Center/Subwoofer In" jack. You will still get low frequency response from the AMR130 System. The "Center/Subwoofer In" jack is a switch; when there is no "Center/Subwoofer In" connection, the AMR130 System functions as a 2. 1 or 4. 1 system (depending upon whether you have a 2 channel or 4 channel soundcard). The amplifier's low pass filter automatically switches from the "Center/Subwoofer In" jack to the "Front In" jack when the system senses no "Center/Subwoofer" input. Be aware that the Center Channel does not function in 2. 1 or 4. 1 systems. (For that, you need to upgrade your soundcard to 5. 1. ) FOR SINGLE-LINE OUT, STEREO/2-CHANNEL SOUNDCARDS (Figure 2) For 2. 1 mode (no Center Channel function). FOR DUAL-LINE OUT, 4-CHANNEL SOUNDCARDS (Figure 3) For 4. 1 mode (no Center Channel function). Consult your soundcard's user manual or "Help" function for information about configuring the soundcard software. CONNECTING YOUR AMR130 SPEAKERS [FIGURES 4 & 5] Four of the five AMR130 Satellite Speakers are hardwired with speaker wire. The front right Satellite is hardwired with a multi-pin DIN connector. Connect the speakers as shown using push tab connectors (figure 5). Note that one of the wire strands is marked with a red indicator at the end and the other is unmarked. Make certain that you connect the red marked wire to the red (+) terminal on the amplifier and the unmarked strand to the black (-) terminal on the amplifier. VOLUME AND BLENDING CONTROLS " Turn the system ON by pushing the MASTER POWER switch on the Subwoofer. " Turn the ON/OFF-VOLUME knob (on the right "Master" Satellite) clockwise to ON. The LED on the Satellite will glow green. " Put on a multi-channel source (game or DVD) and set the Satellite's VOLUME knob to a comfortable listening level. " Set the FRONT/REAR BALANCE with the FADER knob (located behind the VOLUME control on the right Satellite speaker). [. . . ] You may also contact us via email: polkcs@polkaudio. com. Log on to www. polkaudio. com to register your new speakers (and write your own review of them!); join Club Polk; get on the mailing list for the Polk Audio FREE quarterly Newspaper, and pick up some nifty logowear and stuff. For accessories and information visit www. polkaudio. com 3 Figure 1a 5. 1 Soundcards including Soundblaster Live and Turtle Beach. Yellow Center Right Rear Left Front Center/Sub In (Yellow) Left Rear Right Front DIN Green Rear In (Black) 12VAC 4. 5A Black Front In (Green) Figure 1b 5. 1 Philips PSC706 Soundcard Adapter cable included with Philips sound card Center Right Rear Left Front Center/Sub In (Yellow) Left Rear Right Front DIN Green Rear In (Black) 12VAC 4. 5A Black Green Front In (Green) Yellow Figure 2 Single-line out, stereo/ 2-channel soundcards. Green Center Right Rear Left Front Center/Sub In (Yellow) Left Rear Right Front DIN Rear In (Black) Use "Y" Cable (3. 5mm to 3. 5mm) or Single Front In For Stereo Play 12VAC 4. 5A Front In (Green) Figure 3 Dual-line out, 4-channel soundcards Green Black Center Right Rear Left Front Center/Sub In (Yellow) Left Rear Right Front DIN Rear In (Black) 12VAC 4. 5A Front In (Green) 4 Contact Polk Audio Customer Service 1-800-377-7655, polkcs@polkaudio. com Figure 4 Figure 5 Figure 6 Red indicator is on the tips of the positive wires. These connect to the red (+) speaker terminals. Center Right Rear Left Front Left Rear Right Front DIN Figure 7 Figure 8 Figure 9 Depress lever to adjust Figure 10 Figure11 a b For accessories and information visit www. polkaudio. com 5 AMR130 5. 1 Computer Speaker System Product Specifications Frequency Response Input sensitivity for maximum output S/N Ratio Max SPL @ 0. 5 m Surround Satellite Dimensions Center Channel Dimensions Subwoofer Dimensions Satellite Drivers Center Channel Driver Long-Throw Subwoofer Total System Power 37 Hz - 21 kHz 0. 05 (volts) >90 dB 106 dB 7"H x 5x"W x 34"D 44"H x 74"W x 3"D 8z"H x 64"W x 134"D 3" Full Range Driver 3" Full Range Driver 54" 40 Watts RMS (80 Watts Peak) POLK AUDIO LIMITED WARRANTY Polk Audio, Inc. warrants to the original purchaser only that this Polk Audio Loudspeaker Product (the "Product") will be free from defects in materials and workmanship for a period of one (1) year from the date of original retail purchase from a Polk Audio Authorized Dealer. [. . . ]