User manual POLK AUDIO DSW MICROPRO 3000

[. . . ] Product Disposal-- Certain international, national and/or local laws and/or regulations may apply regarding the disposal of this product. For further detailed information, please contact the retailer where you purchased this product or the Polk Audio Importer/Distributor in your country. A listing of Polk Audio Importer/Distributors can be found on the Polk Audio website www. install in accordance with the manufacturer's instructions. [. . . ] When no signal is present, the subwoofer will enter a "waiting" state after 15 minutes and the LED will turn yellow. On With the switch in this position, your subwoofer is always on and fully active. the LED on the back of the subwoofer will be green. This mode is best if the subwoofer is plugged into a switched power outlet. The remote control cannot be used to turn off the subwoofer. Note: You may want to leave your subwoofer unplugged or the AC MAIN switch turned off during extended periods of non use, such as during a vacation. (Artwork not to scale) (Artwork not to scale) OPTION #1 Receivers that include a "SUB OUT" feature-- the most common hookup method with Dolby Digital® and DTS® receivers. ⷠConnect a single RCA cable from the "SUB OUT" of your receiver to the LFE input of the subwoofer. This connection method bypasses the subwoofer's internal filter and relies on the low-pass filter built into your receiver. Do not use speaker wire to make the connection to the subwoofer. Depending on your front speakers' bass output capabilities, set the crossover frequency on the receiver to 80Hz for tower and bookshelf speakers (speakers with a woofer 5 1/4" in diameter or larger) and 100-120Hz for satellite speakers. Note: Do not use the line or LFE input in this configuration. ⷠConnect the left and right front speaker outputs of your receiver to the speaker level inputs of the subwoofer using speaker wire (see "Making Binding Post/Speaker Wire Connections" for detailed instructions). ⷠConnect the left and right front speaker outputs of your receiver directly to the speaker inputs of your front speakers. ⷠConnect the center channel speaker directly to the center channel output from your receiver. Making Binding Post/Speaker Wire Connections There are two pair of speaker input terminals on the rear of the subwoofer. Each pair has one terminal marked red (+) and the other black (-). Make certain that you connect the wire from the red (+) terminal of your receiver to the red (+) terminal on your subwoofer and the wire from the black (-) terminal of the receiver to the black (-) terminal on your subwoofer. Speaker wire has some indication (such as color coding, ribbing, or writing) on one of the two conductors to help maintain consistency. Strip 1/2" (12mm) of insulation from each of the two conductors on both ends to expose the bare wire. Twist the exposed wire of each conductor to form two un-frayed strands (one on each end). Note: When you set up your subwoofer for the first time, you will probably have to make adjustments several times before you hear what you personally like. [. . . ] This warranty will terminate automatically prior to its stated expiration if the original retail purchaser sells or transfers the Product to any other party. , warrants, to the original retail purchaser only, that the LOUDSPEAKER(S), PASSIVE CROSSOVER COMPONENT(S) and ENCLOSURE on this Polk Audio Loudspeaker Product will be free from defects in material and workmanship for a period of five (5) years from the date of original retail purchase from a Polk Audio Authorized Dealer. , warrants, to the original retail purchaser only, that any AMPLIFIER OR OTHER ELECTRONIC COMPONENT that may be included in this Polk Audio Loudspeaker Product will be free from defects in material and workmanship for a period of three (3) years from the date of original retail purchase from a Polk Audio Authorized Dealer. To allow Polk Audio to offer the best possible warranty service, please register your new product online at: www. [. . . ]