User manual POLK AUDIO SR124

[. . . ] Product Disposal - Certain international, national and/or local laws and/or regulations may apply regarding the disposal of this product. For further detailed information, please contact the retailer where you purchased this product or the Polk Audio Importer/ Distributor in your country. A listing of Polk Audio Importer/Distributors can be found on the Polk Audio website www. If you expose your hearing to the loud decibel levels this product is capable of producing, you may experience permanent hearing loss. [. . . ] Keep the carton and packing material; this will do the best job of protecting your subwoofer(s) if it has to be shipped. 5 inch glass/epoxy voice coil former wound with four layers of heavy gauge high temperature Aluminum wire provides the highest power handling (700 Watts Continuous!Voice coil is bathed in cooling air via an extensive network of vents in the pole piece and basket. â· Specially designed curved vanes smooth the airflow to prevent any air turbulence that could cause noise and "chuffing. Spider collar, sandwiched between the dual spiders, ensures precise alignment of the voice coil. Hex-key terminals for clean, professional hookups can accommodate up to 8 gauge speaker wire. The same engineering excellence and performance obsession that went into the SR6500 system has been applied to four new subwoofers--the SR124, SR124DVC, SR104 and SR104DVC. These models are To adequately support the subwoofer in its enclosure, use 3/4" (19mm) to 1" (25. If you intend to mount your SR Subwoofer with the magnet facing out, ensure that the pilot holes are small and that you use mounting screws with an aggressive thread that will seat the subwoofer securely in the baffle. For complete details on building an enclosure for your SR Subwoofer, go to: polkaudio. Make sure that your amplifier is 2 Ohm stable when configured in the bridge mode. Consult your amplifier's owner's manual before wiring in this configuration. NOTE: In order to make it easy to parallel multiple subwoofers, the two positive terminals are connected together. 2 Ohm Parallel Wiring Note: SR104/124DVCs voice coils are wired in a parallel 2 Ohm configuration from the factory. This warranty will terminate automatically prior to its stated expiration if the original retail purchaser sells or transfers the Product to any other party. , warrants, to the original retail purchaser only, that the LOUDSPEAKER(S), PASSIVE CROSSOVER COMPONENT(S) and ENCLOSURE on this Polk Audio Loudspeaker Product will be free from defects in material and workmanship for a period of three (3) years from the date of original retail purchase from a Polk Audio Authorized Dealer. Com/registration or call Polk Audio customer service 800-377-7655 in the USA and Canada (outside the USA: 410-358-3600) within ten (10) days of the date of original purchase. Be sure to keep your original purchase receipt. [. . . ] Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you. All implied warranties on this Product are limited to the duration of this expressed warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitations may not apply to you. This warranty gives you specific legal rights, and you also may have other rights which vary from state to state. [. . . ]