User manual POLK AUDIO TC265I

[. . . ] FIGURE 4 To aim the TCi Tweeter, use your fingers to gently manipulate the outer ring of the tweeter cup, pushing lightly one way or the other to tilt the tweeter, until it is aimed in the direction of your listening position. 3 Get more information and exclusive accessories, visit www. Note: TCi Series In-Wall Loudspeakers are not magnetically shielded and should not be placed closer than 1' (30cm) from a direct view television or video monitor. Test your distance BEFORE INSTALLATION by simply holding the speaker in the place you plan to install it, and seeing how it affects any TVs or video monitors nearby. [. . . ] Wire meeting appropriate building and fire codes must be used. Use at least 18 gauge wire or heavier for the utmost in sound quality. wiring is best performed by an experienced professional. If you are in doubt that you possess the necessary skills or tools, consult your Polk Audio dealer, or a professional installer. Keyhole saw, utility knife or material- appropriate incising implement for cutting drywall or other wall material. Screwdriver, preferably powered, with Phillips head bit. ⷠPower drill with appropriate bit (optional, for starting wall cut). Make sure the material into which you plan to mount the speakers (plaster, drywall, paneling, stone, etc. ) can support the weight of the speakers (see specification page for the weight of your model). ⷠMake sure the locations you select do not conceal studs, electrical wiring or plumbing. Prior to installation, hold the speaker in your chosen location to make sure it safely clears obstacles such as studs, corners, beams, lighting fixtures and door/window frames. Your cutout must be at least 1" (25mm) from adjoining walls or ceiling, internal studs or plumbing. ⷠUsing the template, trace the installation location with a pencil. You can do this by holding the template in your preferred location and tracing around it. Use a level to make certain the template is straight and plumb. Carefully cut the hole with the appropriate cutting tool for your wall or ceiling material. start the hole by drilling a hole on the inside of the tracing (with the drill bit touching the line). Use this hole to insert the saw or knife and begin cutting [figure 10]. ⷠOnce you have cut the hole, fish your previously positioned wiring out of the hole and connect the speaker. Follow the hookup directions inclued with your receiver. Strip 1/2 inch (12 mm) of insulation from each of the two conductors of the wire to expose the bare metal and twist each of the conductors into a single unfrayed strand (so you have two unfrayed strands). Note that one of the terminals on the rear of each speaker is red (+) and the other is black (-). [. . . ] All replaced parts and Products become the property of Polk Audio. Accepts no liability for hearing loss, bodily injury or property damage resulting from the misuse of its products. Keep these guidelines in mind and always use your own good judgment when controlling volume: · High volume in an automobile can hinder your ability to safely operate a vehicle. ⷠYou are responsible for knowing the local laws governing acceptable mobile volume levels. [. . . ]